Haws 8164 Installation Manual
THIS DOCUMENT IS TRUE AND CORRECT AT TIME OF PUBLICATION. CONTINUED PRODUCT IMPROVEMENTS
MAKE SPECIFICATIONS AND MEASUREMENTS SUBJECT TO CHANGE WITHOUT NOTICE.
1" IPS ELBOW & PIPE
(SUPPLIED)
SUSPENDED
CEILING
HANGER BRACKETS
(NOT SUPPLIED)
(AS REQUIRED)
254mm
HOLE DIA.
10"
9 3/8"
238mm
1" IPS PIPE & FITTINGS
(NOT SUPPLIED)
1" IPS PIPE
(NOT SUPPLIED)
1 of 2
Page
10-1/2"
267mm
FLANGE DIA.
REMOVABLE
7-3/4"
198mm
ROUGH-IN
ACCESS
PLATE
82"-96"
2083mm-2438mm
14-3/4"
376mm
ROUGH-IN
16"
408mm
3 1/2"
89mm
9"
3
229mm
NOTES:
1. TO COMPLY WI TH ANSI Z358. 1-2009 FOR EM ERGENCY SHO WER EQUIPMENT:
- UNIT SHALL BE INSTALLED IN ACCORDANCE WITH MANUFACTURER'S INSTRUCTIONS AND
ACCEPTABLE PLUMB ING PRACTICES.
- SHOWER SHALL BE POSITIONED SO THAT SHOWER HEAD IS NOT LESS THAN 208. 3 CM (82 IN.)
NOR MORE THAN 243.8 CM (96 IN.) FROM SURFACE ON WHICH USER STANDS.
- SHOWER SPRAY PAT TERN SHALL HAVE A MINIMUM DIA METER OF 50.8 CM (20 IN.) AT
152.4 CM (60 IN.) ABOVE SURFACE ON WH ICH USER STANDS, AND CENTER OF SPRAY
PATTERN SHALL BE LOCATED AT LEAST 40.6 CM (16 IN.) FROM ANY OBSTRUCTION.
2. DIMENSIONS MAY VARY ±1/2" [12.7mm].
3 INSTALL STAINLESS STEEL CABINET AS CLOSE TO DOOR JAM AS POSSIBLE.
C
2013
Haws Corporation - All Rights Reserved
HAWS and oth er trademar k s used in these materials are the exclusiv e property of H aw s Corporation.
R
HANDLE,
CLOSED
POSITION
ON POSITION
46"
1173mm
MAX
DRAWN:
DO
APPROVED:
REVISED PER
4838
ECN:
DATE:
03/09/00
DATE:
16" MIN
406mm MIN
WALL
3-1/2"
89mm
STAINLESS STEEL
CABINET
1" UNION & CLOSE NIPPLE
(NOT SUPPLIED)
2X
1" BRASS STAY
OPEN BALL VALVE
1 3/8"
35mm
1" IPS
SUPPLY
34 1/2"
876mm
MAX
BY:ECN NO.
MODEL(S)
HM
CHK'D.:
8164
SHOWER
SCALE: SHEET OF
1/19
DRAWING TYPE:
1-5/8"
41mm
REF
INSTALLATION
1" IPS PIPE
(NOT SUPPLIED)
1455 KLEPPE LANE
SPARKS, NEVADA 89431
(775) 359-4712 FAX (775) 359-7424
E-MAIL: HAWS@HAWSCO.COM
WEBSITE: WWW.HAWSCO.COM
SIZE:
PART NUMBER:
0002080138.D
DRAWING NO.:
13622A00 14
12
A
13622A00
DWG. NO.
REV.
THIS DOCUMENT IS TRUE AND CORRECT AT TIME OF PUBLICATION. CONTINUED PRODUCT IMPROVEMENTS
MAKE SPECIFICATIONS AND MEASUREMENTS SUBJECT TO CHANGE WITHOUT NOTICE.
3
16" MIN.
406mm
1" IPS PIPE & FITTINGS
(NOT SUPPLIED)
HALLWAY
WALL
1" IPS HIGH
POLISH NIPPLE
(SUPPLIED)
2 of 2
Page
SUSPENDED
CEILING
10 7/8"
276mm
ESCUTCHEON
TOP VIEW
82" - 96"
WALL
NOTES:
1. TO COMPLY WITH ANSI Z358.1 -2009 FOR EMERGENCY SHOWER EQUIPMENT:
- UNIT SHALL BE INSTALLED IN ACCORDANCE WITH MANUFACTURER'S INSTRUCTIONS AND
ACCEPTABLE PLUMBING PRACTICES.
- SHOWER SHALL BE POSITIONED SO THAT SHOWERHEAD IS NOT LESS THAN 208.3 CM (82 IN.)
NOR MORE THAN 243.8 CM (96 IN.) FROM SURFACE ON WHICH USER STANDS.
- SHOWER SPRAY PATTERN SHALL HAVE A MINIMUM DIAMETER OF 50. 8 CM (2 0 IN. ) AT
152.4 CM (60 IN.) ABOVE SURFACE ON WHICH USER STANDS, AND CENTER OF SPRAY
PATTERN SHALL BE LOCA TED AT LEAST 40.6 CM (16 IN.) FROM ANY OBSTRUCTION.
2. DIMENSIONS MAY VARY ±1/2" [1 2.7mm].
3 INSTALL STAINLESS STEEL CABINET AS CLOSE TO DOOR JAM AS POSSIBLE.
C
Haws Corporation - All Rights Reserved
2013
HAWS and other trademarks used in these materials are the exclusive property of Haws Corporation.
R
2083mm - 2438mm
FOR ALTERNATE "HANG DOWN" INSTALLATION
OF SHOWER HEAD (SHOWN ABOVE) PERFORM
THE FOLLOWING STEPS:
A) SWAP OUT 1" X 5" NIPPLE FOR
1" X 6-1/2" HI POLISHED NIPPLE (SUPPLIED)
B) USE CEILING ESCUTCHEON FOR 1" PIPE (SUPPLIED)
ALTERNATE
"HANG DOWN"
INSTALLATION
1455 KLEPPE LANE
SPARKS, NEVADA 89431
(775) 359-4712 FAX (775) 359-7424
E-MAIL: H AW S@ H AW SCO.CO M
REVISED PER
ECN:
HM
DRAWN:
DO
APPROVED:
4838
DATE:
03/09/00
DATE:
BY:ECN NO.
MODEL(S)
CHK'D.:
8164
SHOWER
SCALE: SHEET OF
1/19
DRAWING TYPE:
INSTALLATION
WEBSITE: WWW.HAWSCO.COM
SIZE:
A
PART NUMBER:
0002080138.D
DRAWING NO.:
13622A00
22
REV.
14
13622A00
DWG. NO .
Loading...