Haws 7778B User Manual

NO. OOO2076521 (0)

INSTALLATION, OPERATION

&

MAINTENANCE INSTRUCTIONS

No. 2080103(15)

LIMITED WARRANTY

hereunder and that HAWS shall not be liable for general, special, or consequential

OR GIVEN BY HAWS.

NOTE TO INSTALLER: Please leave this information with the Maintenance Department.

Model 7778B

SHOULD YOU EXPERIENCE DIFFICULTY WITH THE INSTALLATION OF THIS

1455 Kleppe Lane Sparks, NV 89431-6467 [phone] Fax [phone]

E-mail: [e-mail] website: www.hawsco.com

HAWS warrants that this specific product is guaranteed against defective material or poor
workmanship for a period of one year from date of shipm ent. HAWS liability und er this
warranty shall be discharged by furnishing without charge F.O.B. HAWS Factory any goods,
or part thereof, which shall appear to the Company upon inspection to be of defective
material or not of first class workmanship, provided that claim is made in writing to Haws
within a reasonable period after receipt of the product. Where claims f or defects are made,
the defective part or parts shall be delivered to the Company, prepaid, for inspection. HAWS
will not be liable for the cost of repairs, alterations or replacements, or for any expense
connected therewith made by the owner or his agents, except upon written authority from
HAWS, Sparks, Nevada. HAWS will not be liable for any damages caused by defective
materials or poor workmanship, except for replacements, as provided above. Buyer agrees
that Haws has made no other warranties either expressed or implied in addition to those
above stated, except that of title with respect to any of the products or equipment sold

damages claimed to arise under the contract of sale.
The emergency equipment manufactured by HAWS is warranted to function if installation

and maintenance instructions provided are adhered to. T he units also must be used for the
purpose for which they were intended. This product is intended to supplement first-aid
treatment. Due to widely varying conditions, Haws cannot guarantee that the use of this
emergency equipment will prevent serious injury or the aggravation of existing or prior
injuries.

NO OTHER WARRANTIES EXPRESSED OR IMPLIED ARE AUTHORIZED, PROVIDED

MODEL PLEASE CALL:

TECHNICAL SUPPORT: 1-800-766-5612
FOR CUSTOMER SERVICE: 1-888-640-4297

04/17 Model 7778B Page 1 of 4

Eye/Face Wash Fountain

LOCATION OF UNIT: The Model 7778B Eye/Face Wash should be installed in close

PROBLEM

REPAIR CHECKLIST

1.

No flow.

1. Check the main shut-off valve.

2.

Insufficient water flow.

2.

a.

Verify minimum 30psi fl owing supply
line pressure.

b.

Probable clogging of flow control

control and reassemble head.

3.

Eye/face wash streams do not

3. Possible blocked flow control , s ee
eye/face wash assembly.

4.

Water does not drain properly.

4. Check the main waste line of your

drainage system.

proximity to potential accident areas. It should be clearly identified, free from
obstructions and easy to access.

SUPPLY LINE: The minimum recommended line size is 1/2” IPS with 30-90 psi (2-6
ATM) flowing pressure. Where sediment or mineral content is a problem, an inlet filter
is recommended.

PLUMBING CONNECTIONS: Inlet supply is female 1/2” IPS. Waste outlet is 1-1/4”
IPS.

TROUBLESHOOTING

due to inadequate line flushi ng .
Unscrew eye/face wash head and
remove the four screws to
disassemble head. Clean flow

meet desired eye level.

For more information about Haws products see our website: www.hawsco.com

© 2017 Haws® Corporation – All Rights Reserved
HAWS® and other trademarks used in these materials are the exclusive property of Haws Corporation.

04/17 Model 7778B Page 2 of 4

above solution. Possible non-leveled

building to see if it does handle the
capacity required for the entire