Haws 7620 Installation Manual
HAWS CORPORATION
1455 KLEPPE LANE, SPARKS, NV 89431
775.359.4712 +1.888.640.4297
www.axioneyepod.com
MODEL 7620
COIN NOTCHES USED
TO INSTALL STANDARD
INTERFACE TO FAUCET
SUPPLIED WITH 4
COMMON FAUCET
ADAPTERS TO ALLOW
UNIT TO WORK WITH
ALMOST ANY FAUCET
STANDARD INTERFACE
WITH LOCKNUT
(will fit most faucets)
SUPPLIED WITH
PRE-ASSEMBLED .5 GPM
MULTI-STREAM PCA SPRAY
AND OPTIONAL 1 GPM
SINGLE STREAM PERLATOR
EASY INSTALLATION
1. REMOVE AERATOR FROM YOUR FAUCET.
2. CHOOSE AND INSTALL THE APPROPRIATE ADAPTER BY THREADING IT ON TO
YOUR FAUCET, IF NECESSARY. (THE STANDARD INTERFACE ON THE eyePOD
WILL FIT MOST FAUCETS).
3. REMOVE LOCKNUT AND STANDARD INTERFACE AND INSTALL THEM ON TO
YOUR FAUCET TOGETHER USING COIN SLOTS. A QUARTER WORKS WELL.
TM
4. THREAD THE LOCKNUT BACK ONTO THE eyePOD
TM
eyePOD
NOTE: FAILURE TO INSTALL PROPERLY MAY AFFECT ITS PROPER FUNCTIONING.
IS POSITIONED FACING FORWARD (As shown in Faucet Mode).
MAKING SURE THAT THE
TM
INSTALLATION AND USE NOTES
1. THE eyePODTM IS DESIGNED FOR AND SHOULD ONLY BE USED WITH WATER
BETWEEN 60
EYEWASH STREAMS WILL BE SHUT OFF BY INTERNAL THERMO-STATIC VALVE.
NOTE: USE OF THE PRODUCT WITH WATER OUTSIDE THE STATED TEMPERATURE
RANGE MAY AFFECT ITS OPERATION AND RESULT IN A RISK OF SERIOUS BURNS
OR REDUCE ITS EFFICIENCY.
2. THE eyePOD
SHOULD ALWAYS BE RETURNED TO THE FAUCET MODE AFTER EYEWASH USE
TO ALLOW FOR DRAINAGE.
NOTE: WHEN INSTALLING THIS UNIT, LOCAL, STATE, OR FEDERAL CODES
SHOULD BE ADHERED TO.
NOTE: ANSI Z358.1 COMPLIANT WHEN PROPERLY INSTALLED IN A WATER
SYSTEM PROVIDING PROPER PRESSURE, VOLUME AND TEMPERATURE.
o
F (15oC) AND 100oF (37oC). IF ABOVE 100oF (37oC) THE
TM
IS SELF DRAINING WHEN PLACED IN THE FAUCET MODE. IT
THE eyePODTM IS
SWITCHED BETWEEN
MODES OF OPERATION
BY ROTATING THE HEAD
IN EITHER DIRECTION.
WATER IS STILL ACTUATED
USING YOUR FAUCET
CONTROLS.
EASY TO USE TURN ON FAUCET AND SELECT MODE OF OPERATION
EYEWASH MODEMODE SELECTION FAUCET MODE
ROTATE IN EITHER DIRECTION
Loading...