Haws 7433FP User Manual

NO. OOO2076521 (0)

Model 7433FP

Eye/Face Wash

INSTALLATION, OPERATION

&

MAINTENANCE INSTRUCTIONS

No. 2080048(16)

NOTE TO INSTALLER: Please leave this information with the Maintenance Department.

SHOULD YOU EXPERIENCE DIFFICULTY WITH THE INSTALLATION OF THIS

1455 Kleppe Lane Sparks, NV 89431-6467 [phone] Fax [phone]

E-mail: [e-mail]  website: www.hawsco.com

HAWS warrants that this specific product is guaranteed against defective material or poor
workmanship for a period of one year from date of shipment. HAWS liability under this
warranty shall be discharged by furnishing without charge F.O.B. HAWS Factory any goods,
or part thereof, which shall appear to the Company upon inspection to be of defective
material or not of first class workmanship, provided that claim is made i n writing to Haws
within a reasonable period after receipt of the product. Where claims for defects are made,
the defective part or parts shall be delivered to the Company, prepaid, for inspection. HAWS
will not be liable for the cost of repairs, alterations or replacements, or for any expense
connected therewith made by the owner or his agents, except upon written authority from
HAWS, Sparks, Nevada. HAWS will not be liable for any damages caused by defective
materials or poor workmanship, except for replacements, as provided above. Buyer agrees
that Haws has made no other warranties either expressed or implied in addition to those
above stated, except that of title with respect to any of the products or equipment sold
hereunder and that HAWS shall not be liable for general, special, or consequential damages
claimed to arise under the contract of sale.

The emergency equipment manufactured by HAWS is warranted to function if installation
and maintenance instructions provided are adhered to. The units also must be used for the
purpose for which they were intended. This product is intended to supplement first-aid
treatment. Due to widely varying conditions, Haws cannot guarantee that the use of this
emergency equipment will prevent serious injury or the aggravation of existing or prior
injuries.

NO OTHER WARRANTIES EXPRESSED OR IMPLIED ARE AUTHORIZED, PROVIDED
OR GIVEN BY HAWS.

LIMITED WARRANTY

MODEL PLEASE CALL:

TECHNICAL SUPPORT: 1-800-766-5612

FOR CUSTOMER SERVICE: 1-888-640-4297

03/17 Model 7433FP Page 1 of 4

TROUBLESHOOTING

PROBLEM

REPAIR CHECKLIST

1.

No flow.

1. Check the main shut-off valve.

2.

Insufficient water flow.

2.

a.

Verify minimum 30 psi flow ing supply
line pressure.

b.

Probable clogging of flow control due

and clean rubber flow control.

3.

Eye/face wash streams do not

3. Possible blocked flow control , s ee
eye/face wash assembly.

4.

Water does not drain properly.

4. Check the main waste line of your

drainage system.

LOCATION OF UNIT: The Model 7433FP Emergency Eye/Face Wash should be
installed in close proximity to potential accident areas. It should be clearly identified
free from obstructions and eas y to access.

SUPPLY LINE: The minimum recommended line size is 1/2" NPT with 30-90 psi (2­6 ATM) flowing pressure. Where sediment or mineral content is a problem, an inlet
filter is recommended.

PLUMBING CONNECTIONS: Inlet supply is female 1/2" NPT. Waste outlet is 1-1/4"
NPT.

MAINTENANCE: In freezing conditions, wipe eye/face wash head and dust cover
dry after each use to prevent unwanted ice build up.

to inadequate line flushing. Unscrew
eye/face wash head and adapter.
Disassemble adapter to gain access

meet desired eye level.

above solution. Possible non-leveled

building to see if it does handle the
capacity required for the entire

For more information about Haws products, see our website: www.hawsco.com

© 2017 Haws® Corporation – All Rights Reserved

03/17 Model 7433FP Page 2 of 4

HAWS

®

and other trademarks used in these materials are the exclusive property of Haws Corporation.