Hasbro PlayDoh Creativity Table User Manual
CAUTION:
which are necessary for assembly. Prior to and
during assembly of this product, keep small
parts out of children’s reach. Small parts pose
a choke hazard to children under 3 years.
C rea t iv i t y Ta bl e
C rea t iv i t y Ta bl e
CONTENTS: 8 five-ounce cans and 4 two-ounce cans of PLAY-DOH® Brand
Modeling Compound (Net Weight 48 oz., 1357 grams), tabletop center,
2 tabletop ends, 4 table legs, carousel, roller, ruler, FUZZY PUMPER®
extruder, extruder ring, extruder post, extruder rail, FUN FACTORY®
extruder, 20 cutters and rollers, 4 shelves, 4 crayons, 4 markers, 10 sheets
of paper, bag of screws, and instructions.
Adult assembly required.
Phillips/cross head screwdriver (not included) required for assembly.
This product contains small parts
AGES 3+
22613
™
™
ASSEMBLY
TABLETOP ENDS
1. Fit 2 tabletop ends onto tabletop center.
2.
Turn tabletop assembly
over. Use a Phillips/
cross head screwdriver
to tighten 3 screws into
TABLETOP
CENTER
tabletop center/end on
one side. Repeat for
other side.
3. Push and snap legs onto table as shown. Be sure to match the
letter on the leg with the letter on the table.
NOTE: Be sure
to insert each
table leg at a
slight angle (as
shown). Gently
rock each leg
into place until
an audible
“snap” is heard.
4.
Stand table on legs. Snap
carousel onto tabletop.
Snap FUZZY PUMPER®
post onto tabletop. Snap
FUN FACTORY® extruder
onto tabletop.
5.
Fit 4 shelves into either of
the legs with shelf slots.
6.
Slide roller onto ruler.
ROLLER
RULER
FUZZY PUMPER POST
CAROUSEL
SHELVES
FUN FACTORY
EXTRUDER
Loading...