Page 1
harman/
kardon
55
AMES
COLIRT,
PLAINVIEW, N.
Y.
11
803
CITATION TWELVE DELUXE
Your Citation Twelve installation and operational manual
is
to be modified, as follows:
1.
Page 2 "Citation Warranty"
Paragraph
2
is
modified to read:
"The Citation warranty does not include repair or replacement of the wooden enclosure due
to damage incurred after initial delivery or transportation charges to and from the factory or
an authorized warranty station."
2.
Page 3 "Power Requirements"
Revise item
3
to read:
Locate black and brown wires attached to fuse post. Unsolder brown wire only. On
left
channel remove 1650 ohm
10
watt resistor. Black wire remains on fuse post.
Revise item 5 to read:
Join the
black/white wire you have just removed, with the brown wire removed in step 3 and
solder together to the vacant lug provided
on the lug strip. On left channel, solder the 1650
ohm
10
watt resistor to this lug.
3.
Inside Rear Cover
Replace diagram with rear panel diagram shown below.
RIGHT
OUTPUT
J
L
PREAMPLIFIER
Page 2
harman/ kardon
55
AMES COURT, PLAINVIEW, N.
Y.
1 1803
IMPORTANT NOTICE TO USER
In certain circumstances it may be required to protect your speakers from overload and possible
damage as the Citation Twelve produces in excess of
60
watts,
RMS,
per channel, both channels
driven simultaneously. Although there are many high quality speakers which can handle this
power, it
is
still recommended, as a safety factor, that your speakers be fused for their protection.
The chart below indicates the appropriate size fuse to use with speakers that are conservatively
rated with music power specifications. It has been our experience that very few speakers are
rated in terms of sine wave
(RMS)
power. However, in the event your speaker
is
rated according
to this rigid specification, contact the speaker manufacturer for the comparable music power
rating.
Speaker Rating
Average Program Material
40 Watts
50 Watts
60
Watts
80 Watts
100 Watts
150 Watts
200 Watts
Fast Acting Fuse
For
8
Ohm Speaker
1.0
AMP
1.0 AMP
1
.o
AMP
1.5 AMP
1.5 AMP
1.5 AMP
1.5 AMP
Fast Acting Fuse
For
4
Ohm Speaker
1.5 AMP
1.5 AMP
1.5 AMP
2.0 AMP
2.0 AMP
2.0 AMP
2.0 AMP
'The speaker fuse should be in the positive speaker line and located at or near the speaker input
terminals. It should NOT be located at the amplifier speaker terminals.
The fuse and fuse holder can be obtained at any electronic supply store. You may use either an
in-line or block type fuse, as shown in the drawing below.
IN-LINE FUSE BLOCK TYPE FUSE
Loading...