Harman-Kardon Citation Sub S User Manual

CITATION SUB S

PRODUCT TOUR

Regional power cord

(varies depending on country)

BACK

Status indicator

RESET: Restore factory settings

>5S

Power

GET STARTED

Pairing or disconnected

Connected

10S

(or Citation Bar, Citation Adapt, or Citation Tower)

Citation MultiBeam 700

CONNECT TO ANOTHER SPEAKER

Pairing or disconnected

Connected

10S

>5S

SPECIFICATIONS

• Model Name: CITATION SUB S

• Signal-to-noise ratio: > 80 dB

• Output power: 100 W RMS

• Power Supply: 100 - 240 V ~ 50 / 60 Hz

• Operating temperature: 0°C - 45°C

• 5G WISA transmitter power: < 14 dBm

• 5G WISA modulation: OFDM, BPSK, QPSK, 16QAM

• 5G WISA transmitter frequency range: 5.15 - 5.35 GHz,

5.47 - 5.725 GHz, 5.725 - 5.825 GHz

• Dimensions (W x H x D): 248 x 380 x 248 mm

• Weight: 6.15 kg (13.56 lb)

• Packaging Dimensions (W x H x D): 322 x 430 x 317 mm

• Packaging Weight (Gross): 7.63kg (16.82 lb)

(9.8’’ x 15.0’’ x 9.8’’)

(12.7’’ x 16.9’’ x 12.5’’)

Note: CITATION SUB S is in compliance with European Commission Regulation (EC) No 1275/2008 and (EU) No 801/2013.

Power consumption

• Oﬀ Mode: N/A

• Standby: N/A

• Network Standby*: 2.0 Watts

Time to networked standby: < 20 minutes * This product is designed to be instantly on and ready to

receive signal from WiSA Tx Unit at a moment’s notice, wireless connection must remain active at all times to ensure proper operation. The product is in compliance with the European Union energy legislation. The product will enter into networked standby after 20 minutes without operation, after which it can be re-activated via wireless.

This device complies with Part 15 of the FCC rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3 (B) / NMB-3 (B).

IC Caution: User should also be advised that:

(i) the device for operation in the band 5150 - 5250 MHz is only for indoor use to reduce the potential for harmful interference to cochannel mobile satellite systems; (ii) the maximum antenna gain permitted for devices in the bands 5250

- 5350 MHz and 5470 - 5725 MHz shall comply with the e.i.r.p. limit: and (iii) the maximum antenna gain permitted for devices in the band 5725

- 5825 MHz shall comply with the e.i.r.p. limits speciﬁed for point-topoint and non point-to-point operation as appropriate. (iv) Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250 - 5350 MHz and 5650 - 5850 MHz and that these radars could cause interference and/ or damage to LE-LAN devices.

Les utilisateurs devraient aussi être avisés que

(i) les dispositifs fonctionnant dans la bande 5 150 - 5 250 MHz sont réservés uniquement pour une utilisation à l’intérieur aﬁn de réduire

les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux; (ii) le gain maximal d’antenne permis pour les dispositifs utilisant les bandes 5 250 - 5 350 MHz et 5 470 - 5 725 MHz doit se conformer à la limite de p.i.r.e.; (iii) le gain maximal d’antenne permis (pour les dispositifs utilisant la bande 5 725 - 5 825 MHz) doit se conformer à la limite de p.i.r.e. spéciﬁée pour l’exploitation point à point et non point à point, selon le cas.De plus, les utilisateurs de radars de haute puissance sont désignés utilisateurs principaux (c.-à-d., qu’ils ont la priorité) pour les bandes 5 250 - 5 350 MHz et 5 650 - 5 850 MHz et que ces radars pourrai ent causer du brouillage et/ou des dommages aux dispositifs LAN-EL. Warning: Changes or modiﬁcations to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

+ 16 hidden pages