Harman kardon CITATION 12D User Manual
harman/
55
AMES
COLIRT,
kardon
PLAINVIEW, N.
Y.
11
803
CITATION TWELVE DELUXE
Your Citation Twelve installation and operational manual
1.
Page 2 "Citation Warranty"
2
is
Paragraph
"The Citation warranty does not include repair or replacement of the wooden enclosure due
to damage incurred after initial delivery or transportation charges to and from the factory or
an authorized warranty station."
2.
Page 3 "Power Requirements"
Revise item
Locate black and brown wires attached to fuse post. Unsolder brown wire only. On
channel remove 1650 ohm
Revise item 5 to read:
Join the
solder together to the vacant lug provided
10
ohm
3.
Inside Rear Cover
Replace diagram with rear panel diagram shown below.
watt resistor to this lug.
modified to read:
3
to read:
10
watt resistor. Black wire remains on fuse post.
black/white wire you have just removed, with the brown wire removed in step 3 and
on the lug strip. On left channel, solder the 1650
is
to be modified, as follows:
left
RIGHT
OUTPUT
L
PREAMPLIFIER
J
harman/ kardon
55
AMES COURT, PLAINVIEW, N.
IMPORTANT NOTICE TO USER
In certain circumstances it may be required to protect your speakers from overload and possible
damage as the Citation Twelve produces in excess of
driven simultaneously. Although there are many high quality speakers which can handle this
is
power, it
The chart below indicates the appropriate size fuse to use with speakers that are conservatively
rated with music power specifications. It has been our experience that very few speakers are
rated in terms of sine wave
to this rigid specification, contact the speaker manufacturer for the comparable music power
rating.
still recommended, as a safety factor, that your speakers be fused for their protection.
(RMS)
power. However, in the event your speaker
60
Y.
watts,
1 1803
RMS,
per channel, both channels
is
rated according
Speaker Rating
Average Program Material
40 Watts
50 Watts
60
Watts
80 Watts
100 Watts
150 Watts
200 Watts
'The speaker fuse should be in the positive speaker line and located at or near the speaker input
terminals. It should NOT be located at the amplifier speaker terminals.
The fuse and fuse holder can be obtained at any electronic supply store. You may use either an
in-line or block type fuse, as shown in the drawing below.
IN-LINE FUSE BLOCK TYPE FUSE
Fast Acting Fuse
For
8
Ohm Speaker
1.0
AMP
1.0 AMP
1
.o
AMP
1.5 AMP
1.5 AMP
1.5 AMP
1.5 AMP
Fast Acting Fuse
4
Ohm Speaker
For
1.5 AMP
1.5 AMP
1.5 AMP
2.0 AMP
2.0 AMP
2.0 AMP
2.0 AMP
Loading...