Harbor Freight Tools Wood Lathe Stand Product manual
Wood Lathe Stand
ITEM 68374
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
When unpacking, make sure that the product is intact and undamaged.
If any parts are missing or broken, please call 1-800-444-3353 as soon as possible.
Visit our website at: http://www.harborfreight.com
Copyright© 2011 by Harbor Freight Tools®. All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape
or form without the express written consent of Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described herein. Tools required for assembly and service may not be included.
Specications
Capacity
14” x 40” Woodworking Lathe
with 6” Sander (ITEM 45276)
5. Use on stable, hard, at level surface only.
SAVE THESE
INSTRUCTIONS.
Save This Manual
Keep this manual for the safety warnings and precautions,
assembly, operating, inspection, maintenance and
cleaning procedures. Write the product’s serial
number in the back of the manual near the assembly
diagram (or month and year of purchase if product
has no number). Keep this manual and the receipt
in a safe and dry place for future reference.
Important Safety Information
WARNING Read all safety warnings and
instructions. Failure to follow the warnings and
instructions may result in serious injury.
Save all warnings and instructions
for future reference.
Assembly Precautions
1. Assemble only according to these instructions.
Improper assembly can create hazards.
2. Wear ANSI-approved safety goggles and
heavy-duty work gloves during assembly.
3. Keep assembly area clean and well lit.
4. Keep bystanders out of the area during assembly.
5. Do not assemble when tired or when under
the inuence of drugs or medication.
6. Attach Wood Lathe securely to stand before use.
Some lathes may not secure properly to this stand.
Check the connection carefully before use. If lathe
cannot properly attach do not use it with this stand.
Assembly Instructions
1. Use Carriage Bolts (7), Washers (2), and
Nuts (1) to assemble the Legs (3, 5):
Figure A: Brace Installation
a. Attach the side of the Left-handed Leg (5)
with one hole to the Short Brace (4).
b. Attach the side of the Right-handed Leg (3) with
one hole to the other end of the Short Brace (4).
c. Attach the Long Braces (6) to the other side
of the Legs (3, 5), as shown in Figure A.
d. Repeat a-c for the remaining Legs and Braces.
e. Attach a Leg Connector (8) behind the top
of each Leg (3, 5), as shown in Figure B.
Use Precautions
1. This product is not a toy. Do not allow
children to play with or near this item.
2. Use as intended only.
3. Inspect before every use; do not use
if parts are loose or damaged.
4. Maintain product labels and nameplates. These carry
important safety information. If unreadable or missing,
contact Harbor Freight Tools for a replacement.
Page 2 For technical questions, please call 1-800-444-3353. SKU 68374
Figure B: Leg Connector Installation
Loading...