Harbor Freight Tools Welding Cabinet Product manual

Specifications

Weight Capacity 286 lb
Overall Dim. 33-1/2″ L X 19-1/2″ W X 33″ H

Important Safety Information

Assembly Precautions

1. Assemble only according to these
instructions. Improper assembly
can create hazards.

2. Wear ANSI-approved safety goggles
and heavy-duty work gloves
during assembly.

3. Keep assembly area clean and well lit.

Use Precautions

1. This product is not a toy. Do not allow
children to play with or near this item.

2. Use as intended only.
Do not sit, stand or ride on cabinet.

3. Inspect before every use; do not use
if parts are loose or damaged.

4. Do not exceed listed weight capacity,
evenly distributed and balanced.
Be aware of dynamic loading!
Sudden load movement may
briefly create excess load
causing product failure.

5. Do not open more than one loaded
drawer at a time to avoid tipping.

6. Maintain product labels and
nameplates. These carry
important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.

4. Keep bystanders out of the
area during assembly.

5. Do not assemble when tired
or when under the influence
of drugs or medication.

6. Weight capacity and other product
capabilities apply to properly and
completely assembled product only.

7. Operate and store the Cabinet
on a flat, dry, level surface.

8. Read welding equipment
manual before use.

9. If using gas cylinders, be especially
careful to prevent tipping or damage
to the cylinders. Follow gas cylinder
supplier’s and gas supplier’s
safety instructions at all times.

10. People with pacemakers should consult
their physician(s) before use.
Electromagnetic fields in close
proximity to heart pacemaker could
cause pacemaker interference
or pacemaker failure.

Page 2 For technical questions, please call 1-800-444-3353. Item 61705

Assembly Instructions

Read the ENTIRE IMPORTANT
SAFETY INFORMATION

section at the beginning
of this document including all text
under subheadings therein before
set up or use of this product.

Note: When attaching hardware,

hand tighten only until all parts are
assembled, then use the appropriate
tools to tighten the hardware.

Note: Before assembly, open the Drawers
and remove all parts and hardware.

1. Attach the Casters (13) under

the front of the Housing (22)
using four Screws (18) each.

Housing (22)

Caster (13)

Screw (18)

2. Attach Bottom Panel (15) to bottom

of Housing using six Screws.

Housing

Bottom

Panel (15)

Screws

Page 3For technical questions, please call 1-800-444-3353.Item 61705