Harbor Freight Tools Swivel Handle for Wooden Dolly Product manual

Swivel Handle For Wooden Dolly

( W orks with Harbor Freight Tools SKU # 92486, 93888 and 38970 Furniture Doll ys)

94354

ASSEMBLY & OPERATING INSTRUCTIONS

660 Lb. Towing Ability

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our W eb site at: http://www .harborfreight.com

Copyright © 2006 by Harbor Freight Tools. All rights reserved. No portion of this manual or any artwor k contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools.

For technical questions please call 1-800-444-3353

ASSEMBLY & OPERATING INSTRUCTIONS

The Handle for Wooden Dolly is attached to a furniture dolly (not included) using the four screws included with this product. Position the Handle in the middle of the furniture dolly, as shown in Figure 2. Mark the placement for the scre ws . Use a small diameter drill bit (one smaller than the screws) to drill four pilot holes. Use a Philips Head screwdriver to thread the screw through the Handle and into the furniture dolly (not included), as shown in Figure 2.

The Handle is adjustable from 27-1/2” to 38-1/4”. Remove the Adjusting Bolts, as shown in Figure 1, and move the handle to the desired length. Then insert the same bolts back into the handle and tighten them using a wrench.

The Handle comes with a plastic Holding Bracket, as shown in Figure 2. After installing the Handle, mark the spot for the Holding Bracket. Drill pilot holes and screw the Bracket into the furniture dolly to secure it.

Figure 1

Mounting Screws

Adjusting Bolts

1. Read and fully understand this instruction sheet before using the Handle.

2. The maximum towing capacity is 660 LBS. Do not exceed this limit.

Holding Bracket

Figure 2

3. Always wear ANSI-approved safety goggles when working with tools and equipment.

4. Alwa ys k eep arms, f eet, legs , etc. out from under the furniture dolly. Children should always be kept at a safe distance. Never allow children to play with or ride on a dolly.

5. Mak e sure the Handle for the W ooden Dolly is securely connected to the furniture dolly before attempting to move any furniture.

6. The furniture dolly should only be used on a flat and lev el surface. Make sure the load is evenly distributed on the furniture dolly before moving it.

SKU 94354 Page 2