Harbor Freight Tools Solar House Address Number Plaque Product manual

Specifications

Wall Bracket Dimensions 3.62″ L x 1″ W

Battery Type One “AA” NiCd

Solar Panel 2.12″ L x 0.75″ W (3 Solar Panels)

Important Safety Information

Installation Precautions

1. Install only according to these
instructions. Improper installation
can create hazards.

2. Wear ANSI-approved safety goggles
and heavy-duty work gloves
during installation.

3. Keep installation area clean and well lit.

4. Keep bystanders out of the
area during installation.

5. Do not install when tired or
when under the influence of
alcohol, drugs or medication.

Maintenance Precautions

1. Wipe away snow or debris on the
Solar Address Panel regularly.

2. Use only Batteries of the type
recommended, ‘AA’ NiCd.

6. This product is not a toy. Do not allow
children to play with or near this item.

7. Inspect before every use; do not use
if parts are loose or damaged.

8. Verify that installation surface
has no hidden utility lines before
drilling or driving screws.

9. The brass components of this product
contain lead, a chemical known to
the State of California to cause birth
defects (or other reproductive harm).
(California Health & Safety Code

§ 25249.5, et seq.)

3. Position battery in proper polarity.

4. Remove the battery before storage.

Page 2 For technical questions, please call 1-800-444-3353. Item 92650

Installation Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.

Assembly of House Numbers

1. Remove the Screws (10)
from the Back Board (8).

2. Remove the small screw on the
side/center of the Housing (1).

3. Remove the Back Board, the Reflector
Box (7) with the Circuitry (3), and the
Number Board (6). See Figure A.

Note: Be careful to not stretch the wiring
when setting the Circuitry aside.

Back Board (8)

Reector Box (7)

Circuitry (3)

4. With the Number Board (6) out,
select the numbers from the
Number Labels (12).

5. Peel backing from numbers and place
them carefully on the Number Board (6).

6. If placing on inside of the panel,
be sure you reverse the number
so the address reads correctly
when placed back in frame.

Screw (10)

Housing (1)

Figure A

7. Replace the Number Board (6) and the Reflector Box (7), including Circuitry (3),
positioning as before, being careful not to stretch or crimp wires. See Figure B.

Number

Board (6)

Housing (1)

Figure B

Page 3For technical questions, please call 1-800-444-3353.Item 92650