Harbor Freight Tools Self Centering Drill Press Jig Product manual
Drill Press Jig
®
92046
Safety Precautions and Instructions
TO PREVENT SERIOUS INJURY, READ AND UNDERSTAND
ALL WARNINGS AND INSTRUCTIONS BEFORE USE.
3491 Mission Oaks Blvd./Camarillo, CA 93011
Copyright© 2005 by Harbor Freight Tools®. All rights reserved. No
portion of this instruction sheet or any artwork contained herein may be
reproduced in any shape or form without the express written consent of
Harbor Freight Tools.
For technical questions, please call 1-800-444-3353.
1. Always wear ANSI approved safety goggles during use.
2. Read and adhere to all warnings, operation instructions, and
safety precautions outlined in this instruction sheet and those
outlined in the owner’s manual for the press that this item is to
be used with.
3. Before every use, check for any broken parts or mounting
fixtures, and any other condition that may affect proper operation.
Any part that appears damaged should be carefully checked to
determine that it will operate properly and perform its intended function.
4. Do not use this jig if under the influence of alcohol or drugs.
Read warning labels if taking prescription medicine to determine if
your judgment or reflexes are impaired while taking drugs. If there is
any doubt, do not use this tool.
5. Stay alert. Watch what you are doing, use common sense. Do not
use this tool if you are tired.
The warnings, cautions, and instructions discussed in this
instruction sheet cannot cover all possible conditions and situations
that may occur. It must be understood by the operator that common
sense and caution are factors which cannot be built into this set, but
must be supplied by the operator.
SAVE THIS INSTRUCTION SHEET.
Operation
Instruction on Back.
Operation Instructions
1. Firmly secure the jig to the table of the drill press. The manner of this
will vary; carefully follow the instructions provided with the drill press
for attaching such accessories. If such instructions are unavailable,
consult a qualified technician for proper procedures.
2. Make sure that the jig is centered di-
rectly underneath the center of the drill.
3. After the jig is mounted properly and
securely in the correct location, place
a round piece of stock inside the jig.
Secure the stock firmly using tie-
downs, clamps, or other appropriate
means.
Note:If the stock is not perfectly round, it may
not seat inside the jig properly. Only
work on stock that is firmly secured.
4. Following the instruc-
tions provided with the
drill press, drill a hole
into the stock to the
chosen depth, being
careful not to drill into
the jig.
5. Remove the work-
piece from the jig.
Note: Drill press not included.
6. Remove the jig if it is not to be used for the next project.
ITEM 92046
Loading...