Harbor Freight Tools 95500 User Manual
SOLAR INSECT KILLER
Model
95500
®
WITH LIGHT
ASSEMBLY & OPERATING INSTRUCTIONS
Due to continuing improvements, actual product may differ slightly from the product described herein.
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
TO PREVENT SERIOUS INJURY, READ AND UNDERSTAND
ALL WARNINGS AND INSTRUCTIONS BEFORE USE.
Copyright© 2006 by Harbor Freight Tools®. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
For technical questions or replacement parts, please call 1-800-444-3353.
SPECIFICATIONS
Overall Dimensions 5-7/8” L x 5-7/8” W x 6-1/8” H
Solar Panel Dimension 2.62” L x 2.62” W
Polycrystalline Solar Panel 60 mA - 0.24 W
Batteries 600 mA AA NiCd Batteries - Qty. 2 - (included)
LED Lights-2 Modes
Running Time 8 Hours on Fully Charged Batteries
Net Weight 0.8 lb.
You will need this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures, parts list and assembly diagram.
Keep your invoice with this manual. Write the invoice number on the inside of the front
cover. Write the product’s serial number in the back of the manual near the assembly diagram, or write month and year of purchase if product has no number. Keep this manual
and invoice in a safe and dry place for future reference.
Single LED Light (1 White LED)
Pest Attracting Light (2 Ultraviolet LED)
Save This Manual
1.
2.
3.
4.
5.
6.
GENERAL SAFETY RULES
WORK AREA
Keep work area clean. Cluttered areas invite injuries.
Check for damaged parts. Before using any product, any part that appears
damaged should be carefully checked to determine that it will perform its intended
function. Check for any broken or damaged parts and any other conditions that may
affect its operation. Replace or repair damaged or worn parts immediately.
Always check hardware and assembled parts after assembling. All connec-
tions should be tight and hardware tightened.
Keep children away. Children must never be allowed in the work area. Children
should not be allowed to play or touch this product because of high voltage. Also
keep pets away front the Solar Insect Killer with Light.
Use eye protection. Always wear ANSI-approved impact safety goggles when
setting up this product.
Maintain products with care. Keep the Solar Insect Killer with Light clean for better
and safer performance. Follow instructions for set up. Be sure the Solar Insect Killer
is in the OFF position before cleaning off bugs. Clean with a dry brush. Be careful
not to damage the electric grid. Keep the Solar Panel clear of dirt and dust with a
damp cloth. Inspect periodically.
For technical questions, please call 1-800-444-3353.
Page 2SKU 95500
7.
People with pacemakers should consult their physician (s) before using this
product. Electromagnetic fields in close proximity to a heart pacemaker could cause
interference to or failure of the pacemaker.
UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
Note: For additional information regarding the parts listed in the following pages, refer to
the Assembly Diagram near the end of this manual on page 8.
Installation Operation
Note: The Solar Insect Killer with Light can be configured in two designs. One design is as
a Light that resembles a Lantern. The other design is a Solar Garden Light with a
stake that goes into the ground.
1.
2.
As a Solar Garden Light, insert the assembled Stake (17, 18, 19, & 20) into a
flat and level surface. Choose an area where the sunlight falls directly onto the
Solar Panel (2). Insert the sharp end of the Stake into the ground, deep enough to
hold firmly. Be sure you have avoided any underground wiring or plumbing. Attach
the Light firmly on the top of the Stake. See the cover photo. Make sure the area
is not accessible to children or pets and that the area has no plant debris nearby
that can fall on the unit.
As a Lantern design, remove the Stake. You need to place the lantern in a area
where the Solar Panel (2) can be charged with direct sunlight while hanging. Lift the
Hook (1) and connect it to a chain or hook from a beam or door jam. Avoid hanging
it too low where bodily injury could happen. See Figure 3.
For technical questions, please call 1-800-444-3353.
Page 3SKU 95500
Loading...