Harbor Freight Tools 69898 Owner's Manual

Important Safety Information

1. Study, understand, and follow all
instructions before operating this device.

2. Do not exceed rated capacity.

3. Use only on hard level surface.

4. Before moving a trailer, assure that the
load is centered and coupler secured.

5. No alterations shall be
made to this product.

6. Wear ANSI-approved safety goggles
and heavy-duty work gloves
during assembly and use.

7. Keep clear of trailer’s path while
placing on and removing from dolly,
and while moving.

8. Use as intended only.
Do not use for aircraft purposes.

9. Inspect before every use;
do not use if parts loose or damaged.

10. Be aware of dynamic loading!
Sudden load movement may briefly create
excess load causing product failure.

11. Read trailer owner’s manual and
instruction manual for Tongue Jack
(not included) before use.

12. Do not work under Trailer while on Dolly.

13. Keep area free of spectators and do not
allow anyone on trailer while on Dolly.

14. Use wheel chocks when raising front
of trailer for placement onto Dolly.

15. Assemble only according to instructions.
Improper assembly can create hazards.

16. Keep assembly area clean and well lit.

17. Weight capacity and other product
capabilities apply to properly and
completely assembled product only.

18. Do not assemble when tired
or when under the influence of
alcohol, drugs or medication.

19. This product is not a toy. Do not allow
children to play with or near this item.

20. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.

Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this document including all text under subheadings therein
before set up or use of this product.

Assembly

1. Attach V-Support (F), Connector (C),
and Brace (D) to Handle (A) using three
Bolts (1), Lock Washers (3), and Nuts (2).

2. Attach Connector (C) under
Axle Base (B), using two Bolts (9),
Lock Washers (3), and Nuts (2).

Page 2 For technical questions, please call 1-800-444-3353. Item 69898

3. Attach Brace (D) to Axle Base (B), using
Bolt (4), Lock Washer (6), and Nut (5).

4. Slide the Wheels (G) over the ends of
the Axle Base (B) and secure in place
with Washers (H) and Cotter Pins (I).
Bend Cotter Pins into place.