Harbor Freight Tools 69887 Owner's Manual

Specifications

Weight Capacity 750 lb.

Assembled Dimensions 31" L x 35-1/4" W x 35" H

Face Plate 10-1/8" W x 6" H x 5/16" thick

Important Safety Information

Assembly Precautions

1. Assemble only according to these
instructions. Improper assembly
can create hazards.

2. Wear ANSI-approved safety goggles
and heavy-duty work gloves
during assembly.

3. Keep assembly area clean and well lit.

4. Keep bystanders out of the

5. Do not assemble when tired

6. Weight capacity and other product

Use Precautions

Failure to heed these instructions may result in
personal injury and/or property damage:

1. Study, understand, and follow all
instructions before operating this device.

2. Do not exceed rated capacity.
Be aware of dynamic loading!
Sudden load movement may
briefly create excess load
causing product failure.

3. Use only on hard, level surfaces.

4. Lock mounting plate rotating
mechanism before applying a load.

5. Assure load is centered and secured
to mounting attachments.

6. Hold Handle while removing the Pin.

7. Wear ANSI-approved safety goggles

8. Do not use for aircraft purposes.

9. Inspect before every use;

10. This product is not a toy. Do not allow

11. Use as intended only.

12. Maintain product labels and nameplates.

area during assembly.

or when under the influence
of drugs or medication.

capabilities apply to properly and
completely assembled product only.

and heavy-duty work gloves during use.

do not use if parts loose or damaged.

children to play with or near this item.

These carry important
safety information. If unreadable
or missing, contact Harbor Freight Tools
for a replacement.

Page 2 For technical questions, please call 1-800-444-3353. Item 69887

Assembly Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.

Post (5)

Rear Beam

(22)

Middle

Beam (14)

Spring

Washer (21)

Bolt (20)

Figure A: Attach Post to Middle Beam

1. Insert Middle Beam (14) into the
receiver at the base of the Post (5).
Align hole in Rear Beam (22) with hole
at base of Post and attach with Bolt (20)
and Spring Washer (21) as shown.

Nut (15),
Spring Washer
(16), Washer (17)

Caster (18)

Bolt (19)

Middle

Beam (14)

Washer (12)

Snap Ring (11)

Wheel (13)

Axle

Figure B: Attach Wheels and Casters

2. Attach Caster (18) to the Middle Beam
(14) using one Bolt (19), Washer (17),
Spring Washer (16), and Nut (15).

3. Slide a Wheel (13) onto each axle
at end of the Rear Beam (22).
Then slide on a Washer (12)
and secure with a Snap Ring (11).

Page 3For technical questions, please call 1-800-444-3353.Item 69887