Harbor Freight Tools 61602 Product manual

Specifications

Storage capacity 2.31 cu. ft.

Inside dimensions 11 in. L x 27-1/2 in. - 34-1/2 in. W x 11-1/2 in. H

Overall dimensions 12 in. L x 35 in. W x 12-1/8 in. H

IMPORTANT SAFETY INFORMATION

Installation Precautions

1. Install only according to these instructions.
Improper assembly can create hazards.

2. Wear ANSI-approved safety goggles and
heavy-duty work gloves during installation.

3. Keep installation area clean and well lit.

Use Precautions

1. This product is not a toy. Do not allow
children to play with or near this item.

2. Use as intended only.

3. Inspect before every use; do not use if parts are
loose or damaged. Before use, check that the “U”
bolts, support plates, and nuts are tightened securely.

4. Lock trailer box before transporting.

5. Follow Department of Transportation (DOT)
regulations.

Mounting Instructions

4. Keep bystanders out of the area during installation.

5. Do not install when tired or when under the
influence of alcohol, drugs or medication.

6. Product capabilities apply to properly and
completely installed product only.

6. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.

7. WARNING: The brass components of this
product contain lead, a chemical known to
the State of California to cause birth defects
(or other reproductive harm). (California
Health & Safety code § 25249.5, et seq.)

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.

1. Place the Box on the trailer tongue (not
supplied) with the wider part near the trailer.

2. Insert a “U” bolt through one of the Plates.
Insert the legs of the “U” Bolt through the holes
in the bottom of the Box to straddle the trailer
tongue bar. Repeat with the other “U” Bolt.

3. Fit a Plate over the legs of a “U” Bolt and hold
in place with two Nuts. Repeat for other side.

4. Tighten all 4 Nuts, firmly clamping the
Box onto the trailer tongue.

NOTE: Two keys are provided. Keep these
in a safe place when not in use.

5. Occasionally apply a lock lubricant to the
lock to keep it in good condition.

Page 2 For technical questions, please call 1-800-444-3353. Item 61602