Harbor Freight Tools 60757 Owner's Manual

Specifications

Light Type White LED

Battery Type AA NiCd

Charge Time 8 hr.

Important Safety Information

1. Assemble only according to these
instructions. Improper assembly
can create hazards.

2. Wear ANSI-approved
safety goggles during setup.

3. Keep assembly area clean and well lit.

4. Keep bystanders out of the
area during assembly.

5. Do not assemble when tired
or when under the influence
of drugs or medication.

6. Position battery in proper polarity and
do not install batteries of different types,
charge levels, or capacities together.

7. This product is not a toy. Do not allow
children to play with or near this item.

Run Time 8-12 hr.

Solar Cells Amorphous Silicon

8. Use as intended only.

9. Inspect before every use; do not
use if parts are loose or damaged,
or if sharp edges are exposed.
This item is fragile and sharp edges may
be exposed if weathered or damaged.

10. WARNING: Some internal components
of this product contain lead, a chemical
known to the State of California
to cause birth defects (or other
reproductive harm). (California Health
& Safety Code § 25249.5, et seq.)

11. Maintain product labels and
nameplates. These carry
important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.

Setup Instructions

1. Twist the Lamp Cover off
the Lamp Housing.

2. Pull out the shipping tab.

3. Replace the Lamp Cover
onto the Lamp Housing.

4. Decide where you want to place
the Solar Light. Choose a location
that receives full, direct sunlight
a minimum of eight hours a day.
The location should not be near
nighttime light sources such as
porch lights or streetlights as this will
cause the Solar Light to remain off.

Page 2 For technical questions, please call 1-800-444-3353. Item 60757

5. Make certain that the path of the Stake
is clear of lines, cables and conduits.

6. Remove the Stake from
the Solar Light Pole.

7. With a rubber mallet, gently tap
the Stake into the ground.

8. Once the Stake is securely
in the ground, slip the upper
Solar Light assembly/Pole back
onto the top of the Stake.