Harbor Freight Tools 60659 Product manual

Specifications

Rated Capacity 4,000 lb.

Length 20 3⁄4"

IMPORTANT SAFETY INFORMATION

Failure to heed this information may result in personal injury and/or property damage:

1. Study, understand, and follow all instructions
before operating this device.

2. Do not exceed rated capacity.

3. Assure load is secured to the device.

4. To be used only with the following:
shop cranes or hoists suitable for load.

5. No alterations shall be made to this product.

6. Do not allow load to swing or drop
violently while lowering or moving.

7. Use as intended only. Do not use for lifting human
weight or overhead lifting. Keep clear of raised load.

8. Inspect before every use;
do not use if parts are loose or damaged.

9. Wear ANSI-approved safety goggles and
heavy-duty work gloves during setup and use.

10. Do not use for aircraft purposes.

11. Do not work underneath, on, or near a lifted load.

12. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.

13. This product is not a toy.
Keep it out of reach of children.

14. Keep bystanders out of the area during use.

15. Do not setup or use when tired or when under
the influence of alcohol, drugs or medication.

16. The warnings, precautions, and instructions
discussed in this instruction manual cannot cover all
possible conditions and situations that may occur.
It must be understood by the operator that
common sense and caution are factors
which cannot be built into this product, but
must be supplied by the operator.

17. WARNING: The brass components of
this product contain lead, a chemical
known to the State of California to cause
birth defects (or other reproductive harm).
(California Health & Safety Code § 25249.5, et seq.)

SAVE THESE INSTRUCTIONS.

Instructions

Assembly

Insert one Chain through each end of Body. Pull each Chain through to its midpoint
to prevent uneven stress, chain slippage, and serious injury.

Operation

1. Attach the Hanger to a Crane or
Hoist (sold separately).

2. Secure the load to the Chains at
each end of the Body.

3. Turn the Handle to move the load to its balance point,
so that it is hanging evenly from the Leveler.

4. The Hanger will move across the
Body while the Handle turns.

5. Lower load and detach Leveler after use.
Do not use to support load for extended periods.

Page 2 For technical questions, please call 1-800-444-3353. Item 60659