Harbor Freight Tools 41005 User Manual

Table of Contents

Specifications ............................................. 1

Safety ......................................................... 2

Installation .................................................. 4

SAFETY OPERATION INSPECTIONINSTALLATION

Operation .................................................... 5

This is the safety alert symbol. It is used to alert you to potential personal injury hazards.

Maintenance ............................................... 6

Parts List and Assembly Diagram............... 6

Warranty ..................................................... 8

WARNING SYMBOLS AND DEFINITIONS

Obey all safety messages that follow this symbol to avoid possible injury or death.

Indicates a hazardous situation which, if not avoided,

will result in death or serious injury.

Indicates a hazardous situation which, if not avoided,

could result in death or serious injury.

Indicates a hazardous situation which, if not avoided,

could result in minor or moderate injury.

Addresses practices not related to personal injury.

IMPORTANT SAFETY INFORMATION

Read all safety warnings and instructions.

Failure to follow the warnings and instructions may result in serious injury.

Save all warnings and instructions for future reference.

Basic Safety Information

Keep work area clean and well lit.

Cluttered or dark areas invite accidents.

Personal safety

1. Stay alert, watch what you are doing and use
common sense when operating a tool. Do
not use a tool while you are tired or under
the influence of drugs, alcohol or medication.

A moment of inattention while operating tools
may result in serious personal injury.

2. Use personal protective equipment. Always
wear eye protection. Safety equipment such

as non-skid safety shoes or a hard hat used for
appropriate conditions will reduce personal injuries.

Service

Have your tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the tool is maintained.

Page 2 For technical questions, please call 1-800-444-3353. Item 41005/67500

Specific Safety Warnings

1. Do not exceed rated capacity.

2. Lock Trailer Jack in vertical position
before applying load.

3. Use on flat, level, hard surface
capable of supporting load.

4. Wear ANSI-approved safety goggles during use.

5. Prevent trailer wheels from moving using
wheel chocks while raising or lowering.

6. Before towing, fully raise trailer jack and
secure properly in its horizontal position.

7. Keep out from under jack and tongue when
applying and releasing load, or moving trailer.

8. Inspect before use. Do not use if
parts are loose or damaged.

9. Use in accordance with the Department
of Transportation (DOT) regulations.

10. Maintain labels and nameplates on the tool.
These carry important safety information. If
unreadable or missing, contact Harbor
Freight Tools for a replacement.

11. Do not use blocks for additional ground clearance.

12. Do not use on round tongue trailer.

13. Apply force to jack vertically only. Side forces will
compromise the jack. Lower trailer tongue height
as far as possible before rolling trailer on jack.
Roll slowly on flat, level, hard surfaces only.

14. Do not climb aboard any vehicle supported by jack.

15. This product is not a toy. Keep it
out of reach of children.

16. Use caution when using the Trailer Jack to move
a trailer without a vehicle. Losing control of
the trailer due to uneven surfaces can lead to
property damage or serious personal injury.

17. Do not disconnect the boat trailer and use this
Trailer Jack to roll the boat down the boat ramp.

18. Follow all state regulations for boat safety and
towing when using Trailer Jack, including using
safety chains securely attached to the towing
vehicle when the trailer is hooked to the vehicle.

19. Not for aircraft purposes.

20. Trailer Jack must always be in the folded up position
(horizontal to ground) when towing the trailer.

21. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.

SAFETYOPERATIONINSPECTION INSTALLATION

SAVE THESE INSTRUCTIONS.

Page 3For technical questions, please call 1-800-444-3353.Item 41005/67500