Harbor Freight Tools 38137 User Manual

Specications

Capacity 1000 lb.

Wagon Deck 4 FT. long, 2 FT. wide

Wheels 10 IN. Turf-Tread Pneumatic Tires

IMPORTANT SAFETY INFORMATION

WARNING Read all safety warnings and instructions.

Failure to follow the warnings and instructions may result in serious injury.

Save all warnings and instructions for future reference.

1. DO NOT ALLOW CHILDREN TO PLAY WITH
OR AROUND THE WAGON. NOT A TOY.

2. Do not ride on this wagon.

3. Do not exceed 1000 lb. weight capacity,
evenly distributed.

4. When loading and unloading the wagon,
be careful of the balance of the wagon.

5. Be careful of the Handle which can tip
and fall from the upright position.

6. Chock the four wheels before loading
or unloading the wagon.

7. Wear ANSI-approved safety goggles during assembly.

8. Inspect before every use; do not use
if parts are loose or damaged.

9. Maintain product labels and nameplates. These carry
important safety information. If unreadable or missing,
contact Harbor Freight Tools for a replacement.

SAVE THESE INSTRUCTIONS.

Assembly

1. Attaching Rear Bracket to Tray

Turn the Tray (B) upside down so that the exposed
screw holes can be seen. Attach the Rear Bracket (C)
to the Tray using two Bolts (M8x38) (I) - for connection
of the main axle portion of the Rear Bracket, and four
Bolts (M6x20) (J) - for connection of the support arms
of the Rear Bracket. All bolts receive both a Spring
Washer (M/O), Flat Washer (N/P), and Nut (K/L).

Rear

Bracket (C)

Main Connection:

Bolt M8x38 (I),
Flat Washer (P),
Spring Washer (O),
Nut (L)

Support Arm
Connection:

Bolt M6x20 (J),
Flat Washer (N),
Spring Washer (M),
Nut (K)

Tray (B)

2. Attaching Turning Bracket to Tray

Attach the Turning Bracket (D) to the Tray using
two Bolts (M8x38) (I) - for connection of the main
axle portion of the Turning Bracket, and two Bolts
(M6x20) (J) - for connection of the front portion
of the Turning Bracket. The rear portion of the
Turning Bracket is attached to the Tray with 2 Bolts
(M6x20) (J). All bolts receive a Spring Washer
(M/O), Flat Washer (N/P), and Nut (K/L).

Support Arm
Connection:

Bolts (M6x20) (J)
Spring Washer (M)
Flat Washer (N)
Nut (K)

Bracket (D)

Turning

Main
Connection:

Bolts (M8x38) (I)
Spring Washer (O)
Flat Washer (P)
Nut (L)

Page 2 For technical questions, please call 1-800-444-3353. Item 38137