Hanwha Techwin SEW3040W User Manual

Overview

Getting to know your Monitoring system

Wireless Monitor

After opening the box, fully charge the monitor before use. After initial charge, recharge as needed.

Front Controls

Monitor Antenna

Receives and sends signals from or to the camera.

Power LED

Indicator turns green when powered. When battery is charging, this LED will in green color.

Sound Level LEDs

Flashes when sound is detected.

4.3” LCD Screen

Displays video from the camera.

Navigation Controls / Button

Viewing Mode: The following controls are used while watching live video from the camera:

•Press the [$] or [%] buttons to increase or decrease the volume.

•Press the [+] button to switch to the next connected camera’s screen or enter SCAN mode.

•Press the [ ] button to zoom in / out the screen.

MENU Button

Press to access from video monitor mode to menu mode operation. In menu mode, press this button will go back to monitor mode with save from selection.

SLEEP Button

Used to turn on / off the screen by press this button. User can turn on the video again by pressing any buttons. If camera is disconnected, monitor screen would be turned on automatically in Sleep mode.

Microphone

When there are pairing between monitor and camera,

There is a function of transmission of audio only.

Navigation Controls / oK/ZooM Button

Use the controls to move and select while in Viewing

Mode, Menu Mode and Zoom Mode.

Menu Mode: Use the [$/%/_/+] button arrows to navigate in Menu Mode. Press the [ ] button to confirm the menu selection.

Zoom Mode: While in zooming, use [$/%/_/+] button to move the screen around.

10 · Overview

Back Controls

TALK Button

Press down and hold the button to talk back to the camera.

Speaker

Produces the sound transmitted from the camera(s).

TALK

-ON -VOX -OFF

Kick Stand

Use to hold the monitor onto a table.

nn `` You must have more than one camera configured on the system when using the functions that requires more than one camera.

Side Controls

Power and VOX ON / OFF Slide Switch	DC 6V Power Input
Set this switch to ON or OFF to turn on/off the wireless monitor,	Connect the included AC power adapter to power and/or
and set to VOX to turn on the VOX mode.	charge the monitor battery.
	(when the monitor is not placed in the optional Charge cradle).

Overview 04

English · 11

Wireless Camera

Front & Back Controls

IR LEDs

Infrared LED’s provide viewing in no / low light conditions.

Microphone

Receives sounds for the area near the camera, and transmits sound from the camera to the monitor.

	Camera Antenna
	Sends & receives signals to or from the monitor.
- ON	DC 6V Power Input
- OFF	Connect the adapter to the camera.

DC IN 6V

Speaker

Produces the sound transmitted from the monitor.

Side Controls

Power LED	PAIRING Button
LED turns on when powered.	Press this button to pair with a monitor.
Power Slide Switch
Turns the camera ON or OFF.
Night vision sensor	PAIRING
Detects light levels where the camera is placed.

12 · Overview