Hanwha Techwin SEW3035WN, SEB1018RW User Manual
WIRELESS MONITORING SYSTEM
User Manual
SEW-3035WN , SEB-1018RW
SPECIFY SERVICE INSTRUCTIONS AND WARRANTY TERMS
FCC NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE
EQUIPMENT.
WARNING
Some adult assembly or installation required.
This product contains small parts that may cause choking. Keep small parts away from
children.
This product is NOT intended to replace proper supervision of children.
You MUST check your child’s activity regularly, as this product will not alert parents to silent
activities of a child.
Before using this product, read and follow all instructions contained in this booklet, and
read and follow all instructions and warnings on the product.
To prevent entanglement with adapter cords, NEVER PLACE THE CORD IN OR NEAR A
CRIB OR PLAYPEN. DO NOT place the product or its AC adapter cords within reach of
children.
ALWAYS KEEP THE TRANSMITTER, RECEIVER AND AC ADAPTERS OUT OF REACH OF
CHILDREN.
NEVER use the transmitter or receiver near water, including near a bathtub, sink, laundry
tub, wet basement, etc.
This product is intended for indoor use only.
This product is not intended for use as a medical monitor and its use should not replace
adult supervision.
Check reception regularly. Test monitor before use and after changing camera location.
Always unplug AC adapters from wall outlets and power sources during periods of non-
use.
The wireless signal transfer range may be shortened if there exists an obstacle such
as a concrete wall
Samsung Techwin Co., Ltd. All rights reserved.
Trademark
is the registered logo of Samsung Techwin Co., Ltd.
The name of this product is the registered trademark of Samsung Techwin Co., Ltd.
Other trademarks mentioned in this manual are the registered trademark of their
respective company.
Restriction
Samsung Techwin Co., Ltd shall reserve the copyright of this document. Under no
circumstances, this document shall be reproduced, distributed or changed, partially or
wholly, without formal authorization of Samsung Techwin.
Disclaimer
Samsung Techwin makes the best to verify the integrity and correctness of the contents
in this document, but no formal guarantee shall be provided. Use of this document
and the subsequent results shall be entirely on the user’s own responsibility. Samsung
Techwin reserves the right to change the contents of this document without prior notice.
Wireless
Monitoring System
User Manual
Copyright
©2011
between.
•
•
•
•
•
•
•
•
•
•
•
This device complies with part 15 of the FCC Rules. Operation is subj ect to the following two conditions:
(1) this device may not cause harmful int erference; and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, p ursuant to
Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equi pment generates, uses, and can radiate radio frequency
energy. If not installed and used in accordance with the instructions, it may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equip ment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and the receiver.
- Connect the equipment to outlet on a circuit different from that to which t he receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications no t expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
“This appliance and its antenna must not be collocated or operation in conjunction with
any other antenna or transmitter. A minimum separation distance of 20 cm must be
maintained between the antenna and the person for this appliance to satisfy the RF
exposure requirements."
To prevent overheating, keep the product and AC power adapters away from any
•
direct sunlight and heat sources such as radiators, heat registers, cooking devices
(e.g., stoves and ovens) and other appliances that produce heat (e.g., amplifiers,
televisions and stereos).
Ensure that the product is well ventilated during use. Avoid contact with pillows and
•
furniture that may block ventilation.
Use only the AC adapters provided with the product, as other adapters may damage
•
the product. Plug the adapters only into standard household current (120 volts AC).
Place the AC adapters avoiding pinch points otherwise you can damage the
adapters.
When an AC adapter is plugged into a power source, DO NOT touch the exposed
•
end of the AC adapter’s cord.
Do not use extension cords with the AC power adapters to avoid entanglement.
•
This product should only be serviced by qualified and authorized Samsung service
•
centers.
Images and sounds are transmitted by the product over public airwaves and
•
transmissions may be picked up by other units.
Caution if you use the system to watch a young child, do not place the camera where
•
the child can reach.
When using the system with only battery power and the charge is low, then the
•
picture and or sound may affected.
If this occurs then please connect the AC power adapter and/or replace with new
•
batteries.
If you are using the optional rechargeable battery then plug in the AC power adapter
•
to recharge.
BATTERY WARNING
When using the product in portable mode, check batteries regularly.
DO NOT use the monitor in portable mode when batteries are low.
•
DISPOSE OF OR RECYCLE BATTERIES PROPERLY IN ACCORDANCE WITH
APPLICABLE LAWS, which may vary by location.
•
Insert batteries with the correct polarity.
•
Do not mix new and used batteries.
•
Remove exhausted batteries from the product.
•
Keep all batteries away from children.
•
THERE IS A RISK OF EXPLOSION IF INCORRECT BATTERIES ARE USED.
•
Do not disassemble or modify the battery pack.
•
Do not use batteries if there is any evidence of leakage or deformity.
Contents
GETTING STARTED
Features ……………………………………………………… 4
Getting to know your Monitoring system …………………… 5
INSTALLATION
How to Install ………………………………………………… 9
Viewing Mode Display ………………………………………… 10
MENU OPERATION
Menu Operation ……………………………………………… 11
APPENDIX
Hardware and CD driver installation ………………………… 14
Troubleshooting ……………………………………………… 15
Specifications ………………………………………………… 16
GettinG Started
Features
Samsung’s digital wireless technology provides excellent image quality and clarity.
•
•
Virtually eliminates interference using a secure and private signal
•
Up to 100m/330ft wireless open space transmission range.
The actual range may vary depending on the use environment.
•
Listen in with exceptional sound clarity
•
Safety warning feature on monitor notifies you when the camera is out of range of the
transmitter.
•
System is expandable up to 4 cameras (additional cameras sold separately).
•
Two-way audio communication.
•
Camera temperature display on monitor.
•
Built-in music player with 4 different tunes.
Camera Features
•
VGA resolution camera.
•
Night vision allows for low-light viewing up to 3.0m/10ft .
Performance varies depending on environmental conditions.
•
Built-in microphone and speaker.
•
Camera can be battery operated for true portable wireless operation.
•
Plays up to 4 different tunes activated from monitor.
•
Temperature sensor.
•
Nightlight
Receiver Features
•
3.5” color LCD monitor/receiver with superior image quality.
•
Video/Audio output for viewing on TV/Monitor or recording on VCR/DVD recorder.
•
Rechargeable lithium polymer battery for true portability.
•
Audio level indicator and alarm.
•
Room temperature display.
What’s Included
The system comes with the following components:
Adapter (2EA) USB Cable
RCA Cable CD
User Manual Warranty Card & Quick Guide
Screws (2EA) & Plastic anchor (2EA) Wire Clips (6EA)
Check your package to confirm that you have received the complete system,
including all components shown above.
· English
Getting to know your Monitoring system
SEW-3035
Wireless Receiver
After opening the box, fully charge the monitor before use. After initial charge, recharge as needed.
Front Controls
Receives and sends signals from or to the camera.
Displays video from the camera.
Used to activate the screen saver mode.
Press the [A/M] or [S
on the Micro SD/SDHC card in search mode.
Navigation Controls / Button
Viewing Mode: The following controls are used while watching live video from the camera:
•
Press the [+] or [–] keys to increase or decrease the volume.
•
Press the [A] key to view cameras in automatic switching mode.
•
Press the [M] key to manually switch between cameras.
M
enu Mode: Use the [+/–/A/M] key arrows to navigate in Menu Mode.
LEEP] button again to release the
Used to delete the recorded data
Press the [
Receiver Antenna
3.5” LCD Screen
SLEEP Button
screen saver mode.
Delete Button
] button to confirm the menu selection.
MENU Button
Press to access the receiver menu.
Press the button again to exit.
Navigation Controls/ Button
Use the controls to move and select while in Viewing
Mode and Menu Mode.
Play/Stop
Used to play or stop playing the recorded data.
Microphone
Transmits audio to the camera when Talk Button is
pressed down and held like a walkietalkie.
01
Getting Started
Back Controls
ON
AV
OUT
DC IN 5V
Press to auto record or manual record during monitoring.
Night Light Button
Press to remotely turn on/off the night light on the camera
(for the camera currently being displayed on the LCD screen).
When the night light is on, an indication icon will be
You must have more than one camera configured on the system when using the functions that requires more than one camera.
`
n
displayed on the LCD screen.
Use to hold the receiver onto a table.
Side Controls
Connect the included USB cable to view video from the receiver
Receiver ON and low battery indication
If the LED blinks then the battery charge is low. Please connect
When the Unit is turned on the LED is solid green.
A Green LED shows battery is fully charged.
Connect the included AC power adapter to power and/or
charge the receiver battery (when the receiver is not placed in
Using this feature will disable the LCD screen. The LCD screen will turn back on when the A/V cable is disconnected.
`
n
USB Port (Optional Use)
to the AC power adapter to charge.
Charging Indication LED
A red LED shows battery is charging.
DC 5V Power Input
the optional Charge cradle).
A/M record
Stand lever
on your computer.
Antenna Locking Switch
Slide the switch to unlocking position, the receiver antenna
will pop up.
Then you can adjust the antenna for better signal reception.
Speaker
Produces the sound transmitted from the camera(s).
Belt hanger
When you carry the receiver, use the belt hanger to hold the
receiver onto your belt.
Talk Button
Press down and hold the button to talk back to the camera
currently being displayed on the LCD screen.
Power Slide Switch
Slide the switch to ON or OFF position to switch on/off the
receiver.
SD Memory Card Compartment
Insert SD memory card.
A/V Out Port (Optional)
Connect the included A/V cable to view video from a TV or
monitor, or record transmissions on a DVD recorder/VCR.
· English
Loading...