Hanwha Techwin SEW 2000W User Manual

FCC RF TEST REPORT

http://www.emc2000.co.kr

Appendix 6.

Report No.: EMC-FCC-R0062

User manual

EMC compliance Ltd.

480-5 Shin-dong, Yeongtong-gu, Suwon-city, Gyeonggi-do, 443-390,Korea
82 31 336 9919 (Main) 82 31 336 4767 (Fax)

This test report shall not be reproduced except in full, Without the written approval.

WIRELESS CAMERA

l

ON OFF

PAIR

DC IN 12V AV OUT DVR CAMERA

P

A

I

R

S

E

B

-

1

0

0

4

R

W

PAIR

DC IN 12V

AV OUT

DVR CAMERA

ON

OFF

User Manual

English

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings, Install in accordance with the
manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves,
or other apparatus (including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding
type plug has two blades and a third grounding prong. The wide blade or the
third prong are provided for your safety. If the provided plug does not fit into
your outlet, consult an electrician for replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.

11. Only use attachments/ accessories specified by the manufacturer.

12. Use only with the cart, stand, tripod, bracket, or table
specified by the manufacturer, or sold with the apparatus.
When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.

13. Unplug this apparatus during lighting storms or when
unused for long periods of time.

14. Refer all servicing to qualified service personnel. Servicing is required when
the apparatus has been damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or
operate normally, or has been dropped.

SPECIFY SERVICE INSTRUCTIONS AND WARRANTY TERMS

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

FCC NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV

INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO
OPERATE THE EQUIPMENT.

SEB-1004RW

moisture, does not

PT01-000907A

WARNING

• STRANGULATION HAZARD - Keep cord out of child's reach. NEVER place
camera or cords within 3 feet of crib or playpen. Never use extension cords
with adaptors. Only use the adaptors provided.

• Some adult assembly or installation required.

• This product contains small parts that may cause choking. Keep small

parts away from children.

• This product is NOT intended to replace proper supervision of children.
You MUST check your child’s activity regularly, as this product will not alert
parents to silent activities of a child.

• Before using this product, read and follow all instructions contained in this
booklet, and read and follow all instructions and warnings on the product.

• To prevent entanglement with adaptor cords, NEVER PLACE THE CORD
IN OR NEAR A CRIB OR PLAYPEN. DO NOT place the product or its
adaptor cords within reach of children.

• ALWAYS KEEP THE TRANSMITTER, RECEIVER AND ADAPTORS OUT OF
REACH OF CHILDREN.

• NEVER use the transmitter or receiver near water, including near a bathtub,
sink, laundry tub, wet basement, etc.

• This product is not intended for use as a medical monitor and its use
should not replace adult supervision.

• Check reception regularly. Test monitor before use and after changing
camera

location.

• Always unplug adaptors from wall outlets and power sources during
periods of non-use.

The wireless signal transfer range may be shortened if there exists an
obstacle such as a concrete wall between.

• To prevent overheating, keep the product and DC power adaptors away
from any direct sunlight and heat sources such as radiators, heat registers,
cooking devices (e.g., stoves and ovens) and other appliances that produce
heat (e.g., amplifiers, televisions and stereos).

• Ensure that the product is well ventilated during use. Avoid contact with
pillows and furniture that may block ventilation.

• Use only the adaptors provided with the product, as other adaptors may
damage the product. Plug the adaptors only into standard household
current (100~240 volts AC).
Place the adaptors avoiding pinch points otherwise you can damage the
adapters.

• When an adaptor is plugged into a power source, DO NOT touch the
exposed end of the adaptor’s cord.

• Do not use extension cords with the DC power adaptors to avoid
entanglement.

• This product should only be serviced by qualified and authorized Samsung
service centers.

• Images and sounds are transmitted by the product over public airwaves
and transmissions may be picked up by other units.

• Caution if you use the system to watch a young child, do not place the
camera where the child can reach.

• This appliance and its antenna must not be collocated or operation in
conjunction with any other antenna or transmitter. A minimum separation
distance of 20 cm must be maintained between the antenna and the
person for this appliance to satisfy the RF exposure requirements.

Samsung Techwin cares for the environment at all product manufacturing stages,
and is taking measures to provide customers with more environmentally friendly
products.
The Eco mark represents Samsung Techwin’s devotion to creating environmentally
friendly products, and indicates that the product satisfies the EU RoHS Directive.

WHAT’S INCLUDED

The system comes with the following components:

Camera 1EA & Receiver 1EA adaptor (2EA)

Camera bracket

Screw 3EA & Plastic anchor 3EA

User Manual & Warranty CardA/V cable 1EA & UTP cable 1EA

GETTING STARTED

+ Powering camera and receiver

Wireless Receiver / Wireless Camera

Plug the adaptor power output cable into the 12V DC input of the
receiver/camera, and plug the power plug into a wall outlet or surge
protector.

l

+ Pairing camera and receiver

This camera will communicate with the receiver once powered on.

`It is highly recommended to pair the camera to the receiver before permanently

mounting the camera.

Wireless Receiver

Press PAIR button on receiver for 1 second, then a
message will be displayed on the screen. The receiver
will count down from 30~0 – you must press the
PAIR button on the camera during this time to
successfully pair the camera.

If the button on the camera is not pressed, the
receiver will return to the view screen, and no pairing will take place.

Wireless Camera

Press the PAIR button on the front of the camera.
Once the camera has been paired, it will be
immediately viewable on the TV or monitor.

+ Installing your camera and receiver

Wireless Receiver

This receiver can only be desktop or table stand.