Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communication. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio and television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try ti correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
The Wireless USB DAC-1 must be installed and used in strict accordance with the manufacturer’s instructions. This
device complies with the following radio frequency and safety standards.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device.
Warning:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
SAR Information
This device meets government requirements for exposure to radio waves. This device is a radio transmitter and
receiver. It is designed and manufactured not to exceed limits for exposure to radio frequency (RF) energy. These
limits are part of comprehensive guidelines and establish permitted levels of RF energy for the population. The
guidelines were developed and confirmed by independent scientific organizations through periodic and thorough
evaluation of scientific studies. The limits include a substantial safety margin designed to assure the safety of all
persons, regardless of age and health. The exposure standard for device employs a unit of measurement known as
the Specific Absorption Rate, or SAR. Under the guidelines for your device, the SAR limit is 1.6 W/kg. The highest
reported body SAR value is 2464MHz 0.096W/Kg.
The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as in
compliance with the FCC RF exposure guidelines. SAR information on this device is on file with the FCC and can be
found under the Display Grant section of http://www.fcc.gov/oet/fccid after searching on FCC ID: XCO-HSP80D81.
Europe-R&TTE Compliance Statement
Hereby, Hansong(Nanjing) Technology Ltd. declares that this equipment complies with the essential requirement
and other relevant provision of Directive 1999/5/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL of march
9,1999 on radio equipment and telecommunication terminal Equipment and the mutual recognition of their
conformity(R&TTE).
CE Declaration of Conformity
Wireless USB DAC-1 is herewith confirmed to comply with the requirements set out in the Council (European
parliament) Directive on the Approximation of the laws of the Member States relating to Electromagnetic
Compatibility of Radio and Telecom device (1999/5/EC). For the evaluation regarding this Directive, the following
standards were applied:
Radio Spectrum Part: EN 300 328 V1.7.1
EMC Part: EN 301 489-1 V1.8.1, EN 301 489-17 V2.1.1
Electrical Safety Part: EN 60950-1: 2006 + A11: 2009 + A1: 2010 + A12:2011
RF Safety Part: EN 62209-2: 2010
Loading...