Hans Grohe 27164001 User Manual
Installation Instructions / Warranty
Raindance Connect
Showerpipe
27164001
2
Raindance Connect Showerpipe
27164001
Suggested installation
Technical Information
Max. water pressure 147 psi
Recommended water pressure 29 - 72 psi
Test pressure 232 psi
Max. flow rate
showerhead 2.5 gpm
handshower 2.5 gpm
Installation Considerations
This unit does not include a water
supply. Use Hansgrohe model
27458XX3 or another supply that
complies with ASME A112.18.1/CSA
B215.1 including ASME A112.18.3.
The installer should be sure that the mounting
location for this product is flat (no projecting
joints or tiles) and that the wall is suitable for
the installation of this product.
The included mounting hardware is suitable for
solid surface walls, such as:
concrete
•
concrete wallboard
•
Recommended tools (not included)
8 mm
2 mm
3 mm
dense natural stone
•
brick
•
gypsum wallboard/plaster fiberboard
•
surfaced with tile, marble, or stone
If this product is to be installed on another type
of wall, such as a fiberglass or acrylic shower
enclosure, please contact the manufacturer of
the enclosure for recommendations regarding
suitable mounting hardware, mounting
locations, and reinforcement.
In Massachusetts, the maximum output
temperature of the shower mixing valve can be
no higher than 112ºF.
grease pencil or other marking tool
level
ruler
2 & 3 mm Allen wrenches
6 mm drill bit
8 mm wrench
Philips screwdriver
waterproof sealant
6 mm
3
4
Installation
Drill the screw holes with a 6 mm bit.
Install the anchors.
If both ends of the showerpipe are mounted on tile,
install the top and bottom mounting wall flanges.
Loading...