Hanna Instruments SUBMERSIBLE ELECTRODE HOLDERS User Manual
HI 6050
SUBMERSIBLE ELECTRODE HOLDERS
HI 6051
HI 6052
Dear Customer,
Thank you for choosing a Hanna product.
This sheet will provide you with the necessary
information for a correct operation. Please
read it carefully before using the holder. If
you need additional technical information,
do not hesitate to e-mail us at
tech@hannainst.com.
Examine carefully the holder and if any damage has occurred during shipment,
immediately notify your Dealer or the nearest
Hanna Customer Service Center.
The Hanna submersible electrode holders
are available in three models:
TOTAL LENGTH 605 mm 1105 mm 1735 mm
SUBMERSION LENGTH 475 mm 975 mm 1605 mm
WEIGHT 0.8 kg (26 oz.) 1.2 kg (44 oz.) 1.7 kg (54 oz.)
FIGURE 1FIGURE 1
FIGURE 1
FIGURE 1FIGURE 1
HI 6050 HI 6051 HI 6052
(23.8") (43.5") (68.3")
(18.7") (38.4") (73.4")
MOUNTING
HOLES
100mm
3.94"
MOUNTING FLANGE FOR
ELECTRODE HOLDER
DIA
120mm
4.75"
The mounting flange (FIGURE 1) is a rugged
PVC piece that mounts directly to the stainless steel bracket on your tank.
FIGURE 2 illustrates the suggested bracket
dimensions used for mounting. Once
mounted, the electrode holder becomes a
protective housing that will extend the life of
your pH and ORP electrodes.
The electrode should be slid into the holder
(FIGURE 3) and hand tightened. The cable
from the electrode will lead up through the
holder and out through the cap on top. The
cable is also shielded inside the holder to
prevent any damage to the insulation. The
protective cap is removable to allow for quick
and simple electrode maintenance and replacement (FIGURE 4 and 5).
FIGURE 2 *FIGURE 2 *
FIGURE 2 *
FIGURE 2 *FIGURE 2 *
45mm
1.77"
200mm
7.90"
45mm
1.77"
3mm
.12"
SUGGESTED MOUNTING BRACKETS TO
MOUNT THE FLANGE (LEFT) ONTO THE TANK.
MATERIAL: STAINLESS STEEL (*not included).
FIGURE 3FIGURE 3
FIGURE 3
FIGURE 3FIGURE 3
FIGURE 4FIGURE 4
FIGURE 4
FIGURE 4FIGURE 4
REMOVABLE ELECTRODE HOLDER CAN
SLIDE IN AND OUT OF MOUNTING
FLANGE WITHOUT NEEDING TOOLS.
DIA
120mm
4.75"
130mm
5.12"
475mm
19"
IMMERSION
LENGTH
DIA
50mm
2"
FIGURE 5FIGURE 5
FIGURE 5
FIGURE 5FIGURE 5
LEVEL
REMOVABLE
ELECTRODE
HOLDER
FIXED
FLANGE
Made in Italy
http://www.hannainst.com
Loading...