2
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS!
When using electric appliances, basic
safety precautions should always be
followed, including the following:
1. Read all instructions.
2. To protect against risk of electrical
shock, do not put cord, plug, base, or
motor in water or other liquid.
3. Close supervision is necessary when
any appliance is used by or near
children.
4. Unplug cord from outlet when not in
use, before putting on or taking off
parts, and before cleaning.
5. Avoid contacting moving parts.
6. Do not operate any appliance with a
damaged cord or plug, or after the
appliance malfunctions, or is dropped
or damaged in any manner. Call our
toll-free customer service number for
information on examination, repair or
electrical or mechanical adjustment.
7. The use of attachments, including
canning jars, not recommended or sold
by the appliance manufacturer may
cause a risk of injury to persons.
8. Do not use outdoors.
9. Do not let cord hang over edge of table
or counter, or touch hot surfaces,
including the stove.
10. Keep hands and utensils out of jar while
blending to reduce the risk of severe
injury to persons or damage to the
blender. A rubber spatula may be used
but must be used only when blender is
not running.
11. Blades are sharp; handle carefully–
especially when assembling, disassembling or cleaning inside blender jar.
12. Do not use a broken, chipped, or
cracked blender jar.
13. Do not use broken, cracked, or loose
cutting blades.
14. To reduce the risk of injury, never place
cutting assembly blades on base
without jar properly attached.
15. Always operate blender with lid in
place.
16. When blending hot liquids, remove
center-piece of two-piece lid. Hot liquids
may push lid off jar during blending.
To prevent possible burns: do not fill
blender jar beyond the 3 cup (750 ml)
level. With the protection of an oven
mitt or thick towel, place one hand on
top of lid. Keep exposed skin away
from lid. Start blending at lowest speed.
17. Screw on cutting assembly firmly. Injury
can result if moving blades accidentally
become exposed.
18. If the jar should turn when the motor is
switched ON, switch OFF immediately
and tighten jar onto cutting assembly.
19. Do not leave blender unattended while
it is operating.
20. To disconnect cord, turn the control to
OFF. Then remove plug from wall outlet.
21. Do not use appliance for other than
intended purpose.