User manual
1. LED Light
2. On/Off
3. DC5V Micro USB Charging Interface
4. Microphone
1. Bluetooth paring process：
3
1
2
4
Bluetooth Speaker
Model: H803.200.086
1、Product Specifications and Functions.
2、Product Instructions
1.1 Press on/off button 5 seconds until it shows red and blue light and the speaker comes out a
notification sound, then the Bluetooth enters the paring mode
1.2 Activate Bluetooth on your phones and set it to search for Bluetooth “NB-S1” and press to
connect. If your phone asks for entering Bluetooth pair code, please enter four zero “0000”.
Once successfully paired, indicator light will flash blue.
1.3 NFC Connection: Active NFC function on your phone, close your phone to the mark NFC
area on the back of the speaker and the phone will be connected automatically.(There is a tip
on your phone and please do as the tip)
2. Function Button Instructions：
2.1 Long press to switch machine.In bluetooth play short press to play pause.Short according
to answer when call, long press the reject.A short while talking on the phone according to long,
according to hang up.Clockwise to the volume, counterclockwise for the volume reduction.
2.2 Charging: The charging jack is Micro USB，and the voltage is 5V 1.5A-2.1A（Remember
not to use the charger below 1.5A in case of charging for a long time）The light shows red
when charging and goes out when finish charging. It will become yellow if it is low power.
Please remember to charge the speaker as soon as possible.
2.3 MIC：Use to call. This area has been covered with waterproof membrane (Please don't let
some sharp things touch it directly)
3、Specifications:
Battery: Lithium 3.7V 500mAH
Charging Voltage: DC 5V
Charging Time: 1.5~2H
Music playing time (Max)：4.5 H
4、Range and Frequency
Operation Range（non-jamming environment）:10M
BT Frequency： 2.402-2.480 GHz
FCC Caution：
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCCID:2AKXM-H803200086
Loading...