Hale FoamLogix 2 1A PPK User Manual

Quick Start Guide

(FoamLogix System, Portable Pro Kit)

THIS QUICK START GUIDE IS ONLY INTENDED AS A BRIEF OVERVIEW TO THE

OPERATION OF THE FOAMLOGIX 2.1A SYSTEM AND IS NOT INTENDED TO BE

A REPLACEMENT FOR THE INSTALLATION/ OPERATION MANUAL (HALE

P/N: 029-0020-74-0) PROVIDED WITH EACH SYSTEM. ALSO AVAILABLE

Operation

1. CLOSE all discharge valves.

2. Set the main power switch ON. (See
Figure 1.)

ON-LINE – WWW.CLASS1.COM.

(Adjusting the choke may be required
if the engine is cold.)

5. If the pump intake is piped to a water
tank with the water level higher than
the eye of the pump impeller, OPEN
the tank –to–pump valve to flood the
pump inlet.

3. Set the throttle to approximately the ¼
position. (See Figure 2.)

4. Start the engine. (See Figure 3 in the
next column.)

Otherwise, the pump runs from a draft
condition. Follow the pump
manufacturers operating instructions
for priming the pump.

6. OPEN the desired discharge valve(s).
(See Figure 4.)

7. Adjust the throttle to set the operating
water pressure and flow rate. (See
Figure 5.)

The FoamLogix display shows the
current water flow rate.

8. Start foam flow by pressing the red
ON/OFF button ( ) on the
FoamLogix display. (See Figure 6.)

Figure

6

Figure

7

Stop foam flow by pressing
the red ON/OFF button on
the FoamLogix display.

Stop water flow by
closing the discharge
valve(s).

Stop the engine by
placing the main power
switch to the OFF
position.

By repeatedly pressing the DSIPLAY button

(i), water flow rate, foam flow percentage

and water and foam flow totals may be
viewed. (See Figure 8.)

The bar graph on the FoamLogix
display illuminates, left – to–right, to
indicate relative foam motor speed.

9. If needed, adjust the percentage of
foam flow by using the INCREASE
( ) and DECREASE ( ) buttons on













the FoamLogix display. (See Figure 7
in the next column.)

Class 1 ● Unit of IDEX Corporation

607 NW 27th Avenue ● Ocala, FL 34475 U.S.A.

Phone: [phone] ● 352-629-5020

Fax: [phone] ● 352-629-2902

Web........

Figure

8

www.class1.com

Manual p/n: 113964 Rev -, 04/11/2006