Haier XPB40-32 User Manual

User's manual

XPB40-32
Single-tub Washing Machine with pump

Please read this manual carefully before using.
Retain it for future reference

Please check if the power receptacle has good earthing
condition before using to guarantee your safety.

The manufacturer will not bear the responsibility for
those risks occurred from not obeying this manual.

Contents

Before using

Names of the parts...........the 2nd cover

Safety precautions ...........................1

Installation and adjustment ..................3

Using process

Preparation before washing ..............5

Put in the laundries ............................6

Put in the detergent ............................7

Select the wash time ..........................7

Close the top cover .............................8

Finish washing ....................................8

Disposal after washing .........................8

Trouble shooting*Packing list...........9

Specification................the back cover

Names of the parts

Filter cap

Lint filter(Installed by user)

Panel support

Pulsator

cabinet

base

Accessories

Control panel

Draining switch

water inlet

timer knob

handle

power cord

drain hose

back cover

fixing leg
(four pieces)

water inlet hose

( one pc )

Lint filter

( one pc )

Before Using

Before Using

Meaning and description of the symbols

Contents marked with that symbol are related to the safety of the product

and the personal safety of the users. Please operate in strict conformity to

the contents.

Contents marked with that symbol are actions forbidden to perform.

Performing of those action may result in damage of the machine or

influence the personal safety of the users.

Safety precautions

Before Using

Before Using

Please insert the power cord into
special receptacle with rated vol­tage.Be sure to use single-phase
three pins receptacle.The earthing
terminal of the receptacle must be
earthed reliably.If possible,please
adopt electric leakage protector.

When the machine is normally
using, please put the power plug
at the location easily to be insert­ed and extracted by hand. Be sure
to pull the plug off when there's
power failure, or the machine is
being moved, cleaned orwhen it
is idle.

Earth

If the power cord is bad, to avoid risk it is required to replace it by the
technicians ofour special shop or the after-sale service department.
Keep the pin of the power plug clean.

In case the washing machine is installed
on ground with carpet , do not block the
ventilation hole with carpet.

Ventilation hole at
the bottom of the
washing machine

Do not use water hotter than 50 C .

Do not put the machine at damp place
like the bathroom . Never wash it with
water. Do not place wet laundries on the
control panel.

Do not share one receptacle with other
electric appliances. Do not use it in
case that the power plug is damaged
or the inserting into the receptacle is
loose.

Do not wash water-proof laundries such
as the raincoat, bicycle shelter etc. To
avoid abnormal vibration during spinning.

Safety precautions

Before Using

Before Using

Do not stretch hands into the working
machine. It is dangerous even if the
rotation is slow. Take special care of
the children.

Do not put any hot or heavy items
( such as the kettle with hot water )
on the washing machine.

Handicapped or children without care
shall not use the machine.

Do not decompose, repair or alter the
machine by yourself.

Do not wash laundries with volatile
materials (such as thinner, petrol etc.).

l

Petro

Thinner

Keep the machine away from direct
sunlight and heat source like the
heater.

To protect your laundries and washing
machine, please take out all of the coins,
buttons, sand, hairpin and other foreign
materials before washing.

Please check if the water faucet isopen, and if
the connection of the water inlet pipe is proper.
It is suggested to use foamless washing powder.

Before Using

Installation and adjustment

Please install and adjust the machine according to the requirement of
the manual. It is very important to your security and correct operating

the machine.

Before Using

Usage of the drain hose

The drainage shall be smooth with the drain hose.

1.Put the drain hose up to suitable position

<1.2m

2.Do not step on or press the drain hose

Install the lint filter

After opening the package,please take out the lint filter
from the document bag,install it to the filter cap of the
cabinet.See to the figure

Filter cap

Lint filter

Before Using

Before Using

Adjust the installation position

The largest permitted slope of the bearing surface of the washing machine is 2.
Slanting or uneven ground will cause unstable operation of the machine. Please
check with following methods:

Hang a becket with weight to confirm if the washing machine is horizontal.

Install the water inlet hose ; Select the water level

Insert the water inlet hose into the water
inlet jointer on the control panel.
(To dismantle the water inlet hose,you only
need to pull the hose out.)

Fill the water to the water level selected
according to the quantity of the laundries.
Attention:

Put in the laundries first before

water inlet.

Do not exceed the "Max " water
level ( water level 3 ) , otherwise
the water may overflow out of the

Maximum

about 43L

Medium

about 36L

Minimum

about 30L

machine.

water inlet hose

water level
indicator

water inlet jointer

1 Preparation before washing

Preparation before washing

1.Connect the water inlet hose.

2.Confirm that the washing machine is
earthed reliably . Then insert the power
plug into the receptacle. Do not connect
the earth terminal to the gas pipe and
tap water pipe.

3.Hang the drain hose up.

Pay attention to followings before washing the laundries

Using process

Using process

Confirm if
there's special
requirement for
the laundries.

A. Check if the laundries are applicable for washing with machine.
b. Divide the laundries that are not colorfast from other laundries.
c. Put those laundries difficult to absorb water into water with hand.
d. For those laundries with heavy soil, please first remove the dirt like mud or dust.
For the parts with heavy soil, please apply detergent on them in advance, which
can make it easier to remove the soil.
e. For those laundries that may get lint ball and those with long fur, turn it over before
putting in.
f. Do not put those laundries polluted by chemicals into the washing machine directly.

Clear the pocket.
Take out the
coins , sand,
hairpins etc.

Fasten the
buttons and
zippers.

The quantity of
the laundries
shall not exceed
the rated value.
The big laundries
like the jeans
shall be put in
loosely.

When the pulsator
is running , the
buttons of the
laundries may
cause noise. For
the sake of
discretion,please
put the laundries
with buttons into
other laundries.

2 Put in the laundries

The capacity of washing of the machine
refer to the largest weight of the standard
laundries under dry condition that can be
washed in one time. Laundries quantity
in one washing cycle shall be lower
than the rated capacity.

The thickness ,size , type of the cloth will
influence the actual washing capacity. It
is suitable to put in reasonable amount of
laundries and the laundries can be turned
round in washing for one time washing.

Do not select " Maximum " water level
for laundries less than 2.0kg, so as to
avoid splashing of water.

Reference weight of the laundries:

Using process

Using process

cotton,about 900g

pajamas

shirt

cotton,about

300g

working suit up,down

blanket

undershirt

cotton,about 180g

cotton,about 1120g

underpants

cotton,about 70g

jeans about 800g

socking

blending,about 50g

blending coat

about 800g

jacket

cotton,about

800g

single bed sheet

cotton,about 600g

Using process

3 Put in the detergent

Using process

How to use the whitener

Fill water to decided level. Dilute the whitener with container. Pour it slowly into the
washing tub.
Avoid using whitener on laundries with color or pattern as they are prone to lose color.

The whitener shall not touch the laundries directly.
Refer to the user's manual for the usage and quantity of the whitener.
For powder whitener,please dissolve it before using.

How to use the washing powder

Direct dissolved in the machine:

1.Fill small quantity of water.

2.Add the powder . Run for 30 seconds to
dissolve it completely.

3.Put it in the laundries. Select suitable
water level.
The instant dissolving of the washing powder:

1.Prepare warm water of 30 C and a container.

2.Add the powder while stirring to fully
dissolve it.

The powder is more prone to pollute the
laundries than the detergent. Therefore
please use it with proper quantity.

It is suggested not to use high sudsing
detergent.

Dosage of different washing powder is
different. Please refer to the instruction
of the washing powder for the detail
dosage.

Selection of the quantity of the washing powder

Laundries
quantity

4.0kg~3.6kg

3.6kg~2.0kg

Below2.0kg

Water level

Water quantity

Maximum (about43L)

Medium (about36L)

Minimum (about30L)

Concentrated washing
powder

About About

About About

About About

4 select the wash time

Please select wash time according to the laundries.

Laundries

Silk(thin laundries)

Knitwear/chemical fiber

Cotton,blending,linen

Very dirty and thick laundries

Wash time minutes

About2 4~

About3~6

About7~13

About8~10

About10~13

Standard dosage

36g

30g

25g

Common washing
powder

43g

36g

30g

Wash timer

OFF

Using process

5 Close the top lid

Using process

6 Finish washing

The pulsator stops rotating. Push the drain switch down
to discharge the water.

7 Disposal after washing

After using, please clean the lint and foreign materials of the lint filter and lint frame in time.
Otherwise it may influence your using the machine.
Please first pull off the power plug from the receptacle before cleaning.

Cleaning the lint filter

The lint filter must be used during washing.
It must be cleaned in time after each using.

1. Take off the lint filter
Put hand at the indicated position.
Push down to take it off. (See to
Figure 1)

2. Clean the lint
Put it in water and clean while it is still
wet.(See to Figure 2)

3. Install the lint filter
After cleaning, insert the bottom of
the lint filter (marked with "down side")
into the filter frame, then push the
upper part of the filter in (marked with
"up side"). (See to Figure 3)

Attention: be sure not to confuse the direction.

Figure 2

Figure 1

Figure 3

Wipe the complete unit with soft cloth
twisted dry.

Wipe with neutral detergent if too dirty.
Do not wash it directly by water.

Thinner

Petrol

Alcohol

After washing, dismount the water inlet hose.
Pull off the power plug and hang up the
power cord.
Do not store water in the tub for long period.
Discharge the water immediately after each
using.
Wipe off the water drops on the surface and
inside the tub with clean soft cloth. Open the
cover of the wash tub for some time (about
one hour), then close it.
Hang up the drain hose.

Trouble-shooting

The following phenomena are not breakdowns sometimes. Please confirm again before
sending it to repair.

Phenomena How to check

The washing machine
does not act

The drainage does not work.

There's abnormal sound
inside the machine.

Packing list

User's manual

Water inlet hose

Lint filter

Washing machine

Is there power failure?
Is the power plug inserted tightly?

Is the drain hose frozen?
Is the front end of the drain hose blocked?

Is the machine slanting?
Is there metal item inside the tub?

1piece

1piece

1piece

1set

Specification

Type

Model

Rated voltage F

Water level Water quantity about

Rated washing capacity kg

Rated input power W

Rated input power for draining(W)

Dimension(mm)

Weight kg

Injection pressure

requency

Single-tub washing machine with pump

HWM40-32

220V~ 50Hz

1/30L 2/36L 3/43L

4.0

325

35

L510 W420 H810

15

0.02MPa~0.2MPa

810

35

15

5

<1.2m

Earth

HWM40-32

7