Haier WQP6-3 Owner's Manual
Domestic Dishwasher
WQP6-3
GB
Safety precautions
At time of delivery
- Check packaging and dishwasher immediately for signs of
transport damage. If the appliance is damaged, Do not use
it. Contact your supplier without delay.
- Please dispose of packaging materials properly.
During installation
- Install the dishwasher and connect it up in accordance with
the installation instructions.
- The dishwasher must not be connected to the power supply
while installation is being carried out.
- Ensure that the domestic wiring is properly earthed.
- The mains power supply must conform to the details shown
on the dishwasher rating plate.
- Do not connect the dishwasher to the power supply via an
extension cable.
- Not applicable for all models: The plastic housing on the wa ter input contains an electrically operated valve.
- Built-under and built-in appliances should always be installed
under a continuous work surface which is attached to the ad jacent cupboards, in order to ensure that the appliance is en tirely stable.
- After the appliance has been installed, the mains plug should
still be easily accessible.
If a fault occurs
- Repairs or other work on the dishwasher should only be
carried out by a qualified specialist.
- The dishwasher must be disconnected from the power supply
before any repairs or other work are started. Pull the mains
plug out of the wall socket or switch off at the fuse box. Grasp
the plug to remove it from the socket; do not tug on the cable.
Turn the water off at the tap.
When disposing of old appliances
- Appliance that have reached the end of their service life
should be rendered inoperable in order to exclude the pos sibility of subsequent accidents. Pull the mains plug out of
the wall socket, cut through the connecting cable and dis able the door lock.
- Take the appliance to a designated.
During normal use
- Use the dishwasher solely in a domestic environment and for
its designated purpose: washing household tableware and
other utensils.
- Do not place any heavy objects or stand on the door when it is
open. The appliance could tip forward.
- The water inside the dishwasher is not suitable for drinking.
- Do not use solvents of any kind inside your dishwasher. They
could cause an explosion.
- Open the door very carefully if the dishwasher is operating.
There is a risk of water squirting out.
If your family includes children
- Do not permit small children to play with or operate the
dishwasher.
- Keep children away from detergents and rinse-aids.
- Keep small children away from the open door of the
dishwasher. There could still be some detergent left inside.
KNK
GB
Getting to know your dishwasher
llustrations of the control panel and the interior of the dishwasher are shown on the rear cover of this manual. Fold
this page out before you read the manual.
Control panel
1 ON-OFF Button
2 ON-OFF Light
3 Low Salt Indicator Light
4 Handle For Opening Door
5 Knobs For Selecting Cycles
3
2
Appliance interior
6 Salt Container Cap
7 Lower rack
8 Upper rack
9 Middle sprayer Arm
10 Lower sprayer Arm
11 Washing Filter
12 Detergent and Rinse-aid Dispenser
1
6
7
45
8
9
10
11
12
GB
KOK
Water softener
In order to rinse dishes and glasses satisfactorily, the dishwasher requires soft water, i.e. containing little or no lime,
otherwise water stains will be left behind on crockery and
glasses,etc.
If the tap water exceeds a certain level of hardness, it must
be softened,i.e. decalcified, so that it can be used in the
dishwasher.
This is achieved by adding a special salt to the water softener inside the dishwasher.
The water softener, that has the required amount of salt, is
set up according to how hard the tap water is.
Setting up the water softener
- Determine the level of hardness of your tap water. Your
local water company or service agent can help you with
this.
- An arrow can be found on the ring of salt contaiter. The arrow
is initially set at "-".
- When necessary , rotate the ring anti-clockwise from"-" to "+"
in accordance to the hardness of water.
Filling the special salt container
How the salt works
While washing is taking place, salt is automatically rinsed out
of the salt container into the water softener where it dissolves
the lime in the water.
The dissolved lime is pumped out of the dishwasher. The water soltening system is then ready for the next load.
This process of regeneration can only function when the salt is
dissolved in water. Unscrew the lid on the salt container 6 .
Before you use the dishwasher for the first time, pour approx.
1 litre of water into the salt container.
Place the funnel supplied with the dishwasher in the filler hole.
Tip in enough salt to fill the container to the top (maximum of
1.5kg). As you tip in salt, some of the water is displaced and
drains away. When you have done this, clean off any remnants of salt from the area aroud the neck of the container.
Screw the lid back onto the container, ensuring that it is not
cross-threaded.
The Low Salt indicator 3 on the front panel will light up initially
but will extinguish again after a short period when the salt solution has become sufficiently concentrated.
Warning
Do not pour detergent into the container for special
salt. This would destroy the water softener.
LOW SALT Indicator
Add more salt as soon as the LOW SALT Indicator 3 on the
front panel lights up.
KPK
GB
Loading...