Haier WQP12-EFMSA User Manual

Dishwasher
WQP12-EFMS

CODE:0120504082

GB

.1.

NOTICE
Carefully read the instructions contained in this manual,as they
provide importion which is essential to safe and proper installation,
use and maintenace of the appliance.

This appliance complies with following EEC directives:

-73/23/EEC of 19/02/73(Low Voltage)and subsequent
modifications;

- 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and
subsequent modifications.

- Carefully dispose of the packing material.

- After removing the packing,check to make sure that the appli­ ance is not damaged.If in doubt,contact a qualified professional.

- The dishwasher must only be used by adults for the washing of
household dishes and cooking utensils.

- Fundamental rules to follow when using the appliance:
* Never touch the dishwasher when bare foot or with wet hands
or feet;
* We discourage the use of extension cords and multiple sockets;
* During installation,the power supply cord must not be exces­ sively or dangerously bent or flattened;
* If the appliance is not operating properly or,maintenance must
be performed,disconnect the appliance from the power supply.

- Keep detergents out of the reach of children,who must also be
kept away from the dishwasher when it is open.

- This appliance cannot be installed outdoors,not even if the
area in which it is installed is covered by a roof;it is also very
dangerous leave it exposed to the rain and elements.

- Do not touch the heating element during or after a wash cycle.

- Do not lean or sit on the door when it is open ,as this could
overturn the dishwasher.

Safety Is a Good Habit to Get Into

- If the appliance malfunctions,turn off water supply to the appli­ ance and disconnect the plug from the wall socket.Then,con­ sult the section entitled, "Troubleshooting".If you cannot resolve
the problem,contact a service center.

- Only specialised personnel are authorised to make repairs.

- Appliances which are no longer being used must be made
inoperable by cutting the power supply cord and removing the
door lock.

- The appliance must be positioned so that the plug is accessible.

- The carpet must not obstruct the opening when the appliance in­ stalling on the ground with carpet.

- If the supply cord is damaged , it must be replaced by a
special cord or assembly available from the manufacturer or
its service agent.

- The appliance is not intended for use by young children or infirm
person without supervision.

- Young children should be supervised to ensure that they do not
play with the appliance.

- This appliance is intended for built-in and must be installed ac­ cording to the installation instruction and in particuler,it is
required to have the plug accessible after installation.

A
B
C
D
E

ON-OFF Light
ON-OFF Button
Low Salt Indicator Light
Low Rinse Aid Indicator Light

"RAPID"Button

F
G
H
I

"Eco" Button
"1/2 LOAD" Button

Knob For Selecting Cycle

Handle For Opening Door

GB

Close-up View (control panel)

A B C D

I H G F E

Warning:

Dishwasher Detergents are strongly Alkaline.They can be ex­tremely dangerous, if swallowed .Avoid contact with skin and eyes
and keep children away from the dishwasher when the door is
open.
Check that the detergent receptable is empty after completion of
the wash cycle.

.2.

Close-up View (Interior)

A
B
C
D

Upper Rack
Rack Height Adjustor

Top Spray Arm
Lower Rack

E
F
G
H
I

Washing Filter
Bottom Spray Arm

Detergent and Rinse Aid Dispenser

Third Sprayer

Technical characteristics

Width

60 cm

Depth

60 cm

Height

85 cm

Capacity

12 standard place settings

Mains water pressure

0.03-0.6 MPa

Power voltage

220V~ 50Hz

1950W

Total absorber power

Salt Container Cap

GB

.3.

Salt







Salt

The hardness of the water varies from place to place. If hard
water is used in the dishwasher,desposits will form on the dishes
utensils.
The appliance is equipped with a special softener that uses a salt
specifically designed to eliminate lime and minerals from the water.

Loading the Salt into the Softener

Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should
be filled as follows:

- Remove the lower rack and then unscew and remove the cap
from the salt container;

- If you are filling the container for the first time, fill it with water;

- Place the end of the funnel(supplied) into the hole and intro­ duce about 2 kg of salt.It is normal for a small amount of water
to come out of the salt container.

- Carefully screw the cap back on.

The salt container must be filled when the "low salt" indicator light
(located on the control panel),comes on..

To prevent the formation of rust,load the salt just before begin­ning a wash cycle.

Adjusting Salt Consumption

The dishwasher is designed to allow for adjusting the amount of
salt consumed based on the hardness of the water used.This is
intened to optimize and customize the level of salt consumption
so that it remains at a minimum.
To adjust salt consumption,proceed as follows:

- Unscrew the cap from the salt container;

- There is a ring on the container with an arrow on it (see figure to
the side),

- If necessary, rotate the ring in the anticlockwise direction from
the "-" setting towards the "+" sign,based on the hardness of
the water being used.
It is recommended that adjustments be made in accordance with
the following scheme:

Water Hardness

Clarke
degrees

dH

mmol/l

Selector
position

Salt
consumption
(Grams/cycle)

Autonomy
(cycles/2kg)

014

MNT

MNIT

NIUQIQ

NUQQ

NQPS

PSTN

QRUV

QIRUIV

[UV

[TN

[UIV

L

=?J?

jba

L

M

OM

QM

SM

?H?

SM

QM

OR

GB