Haier WM850A User Manual

Full automatic washing machine

User's manual

This manual is for

HWM80-68B

Please read this manual
carefully before using.
Retain it for future reference.

Names of the parts
Safety precautions

Contents

Answers to question

Trouble shooting

Packing list Specification

Installation and adjustment

Usage of the drain hose

Preparation before washing

Put in the laundries

Add the detergent and softener

Use the operation knobs and buttons

Installation the water inlet hose

Disposal after washing

*

Finish washing

Close the top lid

Please check if the power receptacle has good earthing
condition before using to guarantee your safety.

Warning sign

Names of the parts

Meaning and description of the symbols

Forbidding sign

Contents marked with that symbol are related
to the safety of the product and the personal
safety of the users. Please operate in strict
conformity to the contents, otherwise it may
cause damageof the machine or injure the
personal safety of the user.

Contents marked with that symbol are actions
forbidden to perform. Performing of those
actions may result in damage of the machine
or injure the personal safety of the user.

Adjustable foot

Front control
board

Front fixed
foot

Rear fixed foot

back cover

Cabinet

Drain hose

Back faceplate

Control panel
film

Control panel

Lint filter(Installed by user)

Filter cover

Level meter

Power line

Pulsator

Inner tub

Detergent box

Drier outlet
cover

Top lid B

Cabinet handle

Globe cover

Cool water valve

Top lid A

Adjustable foot
seam

hanging hole
for the drain
hose

Safety precautions

Please insert the power cord into
special receptacle with rated vol­tage.Be sure to use single-phase
three pins receptacle.The earthing
terminal of the receptacle must be
earthed reliably.If possible,please
adopt electric leakage protector.

When the machine is normally
using, please put the power plug
at the location easily to be insert­ed and extracted by hand. Be sure
to pull the plug off when there's
power failure, or the machine is
being moved, cleaned or when it
is idle.

If the power cord is bad, to avoid risk it is required to replace it by the
technicians of our special shop or the after-sale service department.
Keep the pin of the power plug clean.

Do not put the machine at damp
place like the bathroom . Never
wash it with water. Do not place
wet laundries on the control panel.

Do not use water hotter than 65 C .

In case the washing machine is in­stalled on ground with carpet, do not
block the ventilation hole with carpet.

The ventilation holes
at the bottom

Do not wash water-proof laundries like
the raincoat, bike covers etc. to avoid
abnormal vibrations in spinning.

Do not let the machine share one receptacle
with other electric appliances. If the power
plug is damaged, or the plugging into the
receptacle is loose, do not use the plug any
more.

Earth

Do not decompose, repair or alter the
machine by yourself.

Do not put any hot or heavy items (such
as the kettle with hot water ) on the
washing machine.

Do not wash laundries with volatile
materials (such as thinner, petrol etc.)

The handicapped or children without
care shall not use the machine.

Keep the machine away from direct
sunlight and heat source like the heater.

Safety precautions

Do not stretch hands into the working
machine. It is dangerous even if the
rotation is slow. Take special care of
the children.

Petro

l

T

h

inn

e

r

To protect your laundries and wash­ing machine, please take out all of the
coins, buttons, sand, hairpin and
other foreign materials before washing.

Please check if the water faucet is open,
and if the connection of the water inlet
pipe is proper.
It is suggested to use foamless washing
powder.

To prevent the lint in the tub from blocking
the cascade outlet and influencing the
cascade effect, please keep the lint filter
in good condition, and install it to proper
position during washing. If the lint filter is
lost or damaged, please contact the local
after-sale service department of our
company.

Install the bottom plate

Adjust the installation position

Soft items

Bottom plate

Screw

Installation and adjustment

Please install and adjust the machine according to the requirement of the manual. It is
very important to your security and correct operating the machine.

Back

Front

After opening the package, please lean the
washing machine gently down on soft items
(like towel cloth, blanket, etc.). Install the
bottom plate to the bottom of the machine
with eight screws by a cross screwdriver,
then lift the machine up gently. See to the
figure:

Loosen

Fasten

High

Low

Adjustable nut

Adjustable leg

The largest allowable slope of the shank base of the machine is 2 .
The slanting or rough ground will result in unstable running or
stoppage of the machine. Please adjust it with following methods:

Confirm it's horizontal:

Adjust the adjustable leg:

If the bulb of the level meter at the balance display
position is inside the standard circle, it indicates that
the machine is horizontal. Otherwise you need to
adjust the adjustable leg of the machine.

1.To twist the adjustable leg, please first lift up the
leg side slightly, loosen the adjustable nut, and
then twist the leg.

2.After adjustment, fasten the nut.

Air bubble

Standard circle

Suitable Not suitable