Haier washing machine Instruction Manual
Automatic Drum Washing Machine
Instruction Manual
Please keep it properly for reference.
Please read the manual carefully before using this machine.
21
Drying function
DD variable-frequency motor
technology
Best door-opening height design
Steel rib integrated structure
Window mat anti-bacterial and
anti-mildew technology
Air washing function
(applicable to XQGH80-HB1466 and XQGH70-HB1266 models)
Double-balanced ring vibration
reduction technology
Self-cleaning function
Drawer dox design
Product Characteristics
Specification
Model
Power
Inflowing water pressure
(MPa)
Rated washing capacity
(kg)
Rated spinning capacity
(kg)
Rated drying capacity
(kg)
Rated spinning speed
(rpm)
Washing noise dB(A
weighted)
Spinning noise dB (
A
weighted )
Energy efficiency rating
Overall Dimension
(H/D/W)
(mm)
XQGH80-HB1466 XQGH70-HB1266 XQGH80-B1466 XQGH70-B1266
220-240V/50Hz
0.03～1.0 0.03～1.0 0.03～1.0 0.03～1.0
8 8
8 8
8 8
8 8
5 5
/ /
1400 1400 1400 1400
50 50 50 50
68
68
B A+++ A+++
1200/680/600 1200/680/600 1200/680/600 1200/680/600
B
68
68
1
20
Displayed
code
Code paraphrase
Troubleshooting methods
The washing machine is in automatic weighting
condition
Normal prompt
Normal prompt
Normal prompt
Normal prompt
Normal prompt
Normal prompt
Level codes of washing quantities for dryer
Shut down of the washing machine
Not meet door opening condition, not allow to
unlock the door lock
Children lock prompt
All procedures end
Normal prompt
Check whether the drain pipe is blocked or bent and clean
the drain filer
Re-close the door of the washing machine. Re-lock the
door after the “Start” key is pressed
Check whether the faucet is opened, the water pressure is too low or
water is cut off. Eliminate it by pressing the “Start/Pause” key. If the
phenomenon still continues, please contact the maintenance
department
Check the adjustable feet and whether the washing machine is steady;
take clothes out and scatter and equally distribute them; if the
phenomenon still continues, please contact the maintenance
department.
Drainage fault
Abnormal locking of the door lock
Abnormal water inflowing
Unequal distribution during dehydration
If the following alarm icons appear, press the “Power” key to shut down the machine for eliminating them; and if they still
appear, unplug the power plug and contact the agency or the manufacturer.
Full-automatic Washing Machine.
Diagrams in this manual are diagrammatic drawings. The appearances and colors of the
product and its parts may be different from those shown in the diagrammatic drawings of
this manual owing to product’s improvement and series expansion, please subject to
material object. Apologize for this.
This machine belongs to class-I appliance, please ensure electrical safety when you use
it.
Please read the manual carefully before using this machine.
Please read carefully safety cautions in the next page that you can safely and correctly
use it.
Level codes of washing quantities for washer
192
1
.
Not damage, process, randomly bend, clamp, twist, unplug or bundle the power line and the
plug.
Not place heavy objects on the power line and the plug.
Not touch, insert or unplug the plug with wet hands.
Stop using a damaged power line and plug as well as a loose socket.
Please use an independent power socket with maximum safe current more than 15A. The
grounding terminal in the socket shall be reliably grounded, and the socket shall be a qualified
product with CE certification.
Please completely insert the power plug into the socket aperture and clean the plug regularly,
since it will cause poor insulation, fire, etc. in case of dust accumulation and moisture.
Ensure that the power plug is unplugged when the washing machine is not used for a long time
or is being cleaned.
The user shall prepare fuses and other overload protection devices with suitable specifications
at home, and the ammeter, the power line and the socket should be able to withstand the
current of 10A.
If the power line is damaged, it must be replaced by the manufacturer, the agent or other
persons with relevant expertise so as to avoid dangers.
Not wash and dry clothes stained with beauty oil, massage oil, edible oil, animal oil, machine
oil, dry cleaning oil, propellant, diluents, petrol, resin and other inflammable substances.
Not place inflammable substances into the roller or near the washing machine.
Not wash, poach or dewater the raincoat, bicycle cover, feather clothing unsuitable for machine
washing, waterproof clothing and carpet, otherwise, it will cause abnormal vibration and
damage to the washing machine and the clothing during the dewatering process.
Not wash the clothing with inflammable cleaning agent, dry cleaning solvent and other chemicals; not use inflammable spraying agent near the washing machine; and not insert or unplug
the power plug of the washing machine during the leakage of coal gas and other inflammable
gas.
Not open the drain filter during the operation, preventing plenty of water from flowing outwards.
Must use a new water inlet pipe and not allowed to reuse a used water pipe.
Safety Cautions
Under the normal operation of the washing machine, the pressure of connected running water
is allowed to be 0.03MPa at minimum and 1.0MPa at the maximum.
Not allow children to look at and enter the inner roller, to avoid injuries and personal safety
accidents of children.
Not place the low rack and bench near the washing machine, to prevent children from touching
the control panel of the washing machine through them.
Not allow children to use the machine independently.
Not place the washing machine in such place with much moisture and vulnerable to wind and
rain, otherwise, water will remain on the electrical appliance, resulting in ignition damage or other
incidents. If water is accidently sprayed or permeated into the washing machine, the machine is
not allowed to use until it is dried by air.
Not directly place the washing machine on an un-ventilated carpet; not block up the ventilation
opening at the bottom thereof; not place the machine close to the wall or the furniture so as to
avoid incidents; and not place the washing machine on a table higher than the ground for use, so
as to prevent the washing machine from falling off.
Not put and extend hands or feet into the lower part of the washing machine.
Not climb to the upper part of the washing machine or place easily-damaged objects on the
washing machine.
Not place the washing machine in such place near heat source, exposed to sunlight and easily
frozen in winter, so as to avoid the aging of plastic parts and rubber parts.
Not touch the inner roller, metal parts, the window screen, the master control board, the distributor
box and metal buttons of clothing during the washing or drying process or in the short time after
drying, to avoid the scalding. Furthermore, not touch the machine when hot water is being
discharged.
Status
Phenomena Others
During
drainage
During dehydration
During
poaching
Poor washing effect
Whether the type and the dosage of cleaning
solution are suitable?
Whether the procedure is correctly selected?
Whether the weight of washings exceeds the rated
washing capacity of the washing machine?
Whether power is accidently off or water is cut off?
The washing machine with the function of stopping
after the cleaning is finished can automatically
increase or reduce poaching times (1-2 times)
according to the dirtiness degree of clothes.
Whether the “Start/Pause” key is pressed?
Whether clothes are tied or wound?
Whether clothes are wound or tied?
Whether the washing machine is collided with
other objects?
Whether foreign bodies enter the washing machine?
Whether the drain pipe is bent, blocked or frozen?
Whether the filter is blocked?
It is caused by the effect of tepefaction of
electronic components, which is normal.
Poor water drainage and inflowing conditions or
unequal distribution of clothes result in time delay.
Different types of clothes result in different
dehydration effects.
Whether the washing machine is in eccentric
protection due to fewer clothes?
Whether the packaging bolts are completely
dismounted?
Whether the washing machine is placed steadily?
(Feet can be adjusted to remain the stability of
the washing machine.)
If the washing machine is set with the procedure of
drainage time, it takes a certain time before
dehydration.
Weak washing
Repeated poaching
No dehydration
High dehydration noise,
with vibration and movement
The dehydration procedure is
conducted, but clothes are still
not dried
No drainage or slow drainage
Reservation time has passed,
but washing still continues.
Local heating of the control panel
Halfway stop during
running process
Before running Troubleshooting methods
Alarm
Note
(It is not allowed to operate the areas with the mark, otherwise, it is likely to damage the
washing machine or endanger the personal safety of users.)
(The contents with the mark relate to product and user’s safety, thus the user shall
undertake the operation in strict accordance with requirements, otherwise, it is likely to
cause damage to the washing machine or endanger user’s safety.)
Loading...