Haier QBJ1-200A58E, QBJ1-270A58E, QBJ1-150A58E, QBJ1-175A58E, QBJ1-230A58E User Manual
...
Solar Water Heater
QBJ1-130A58E
QBJ1-150A58E
QBJ1-175A58E
QBJ1-200A58E
QBJ1-230A58E
QBJ1-270A58E
Instruction for use
Please read this manual before usage
Retain it for future reference
Content
Technical data
Features
Appearance and parts
Technical parameter
Precautions
Before use
Notice
Assembly Instruction
The location
Exterior and installation dimension
Tank assembly
Frame assembly
Frame fastness
Glass tube assembly
Extraventricular plumbing instructions
Indoor plumbing instructions
Installation notice
Pipelines thermal insulation notice
The product with controller installation
and using notice
1
1
1
2
3
3
4
4
5
5
5
6
7
7
8
9
9
Using Instruction
The operation method
Troubles treatment
Packing list
10
11
11
Technical data
Features
1. Inner cylinder:
2. Insulation: Polyurethane foam, thickness-45 mm, good heat preservation effect.
3. Outer shell: Aluminium / zinc coated steel sheet.
4. Frame: Steady structure, shapely and durable .
Appearance and parts
Outer shell
SUS 304 stainless steel, food grade.
Cover
Evacuated tubes
Base support
Technical parameter
Models
Specification of tubes
Collector frame angle
standard fixed
Number of tubes
Aperture area
Usable water
Total water volume
Electric auxiliary
heating
Water level sensor
QBJ1-130A58E QBJ1-150A58E QBJ1-175A58E QBJ1-200A58E
1.79m
QBJ1-230A58E QBJ1-270A58E
58mm 1800mm all glass evacuated tubular collector
45
14
130L
16
2
2.07m
150L 175L 200L
169L 195L 228L 262L
Using the water level sensor with the height of 360 mm
19
2
2.48m
2
2.90m
Rated power: 1500W
22
2
3.35
Silicon seal ring
Frame
Foot cushion
25
m
230L
30
2
4.03
270L
300L 354L
2
m
Remarks:1. The warp of a parameters is 3%. the warp of usable water
perture area
parameters is 5%. The permitted error limit of other parameters is 10%
1
Precautions
Precautions
When using the water heater with electric heating, ensure that electric heating and
1.
electric tracing belt are closed.
2. Avoiding irradiation without water after installation, it can't be used immediately, it
should be sheltered.
3. When supplying water at the first time, it should be operated in the morning or
evening or the condition of short of light; avoid supplying water in strong sunshine,
in order to prevent vacuum tubes bombing.
4. If the water pressure isn't enough for water supply, please install an pressurize
equipment.
5. When the hot water is to be used, don't place the spray head face yourself until the
water temperature is suitable.
6. This product can supply the water depend on the fall of the tank and the water exit ,
an pressurize equipment is recommended while the water couldn't be supplied
normally due to the low fall.
7. Do not supply cold water more than once in a low solar irradiance day.
8. The energy is from solar, in the days that lack of solar such as rainy or snowy day,
the temperature of the water may can't reach your demand,
it may not be used normally.
9. Make sure the evacuated tubes clean, hose off the dust and dirt on the tubes and
the reflector before the winter comes.
10. The evacuated tubes resist as low temperature as -70 when tubes is emptied.
The tank should remain filled up during continuously cloudy or snowing days in winter,
in addition every two days the cold water in the tank should be changed to prevent the
water in the tank from freezing which might damage the tubes.
If there isn't electric heating ,
2
Loading...