Haier HSU-12HV03, HSU-09HV03 User Manual

SPLIT TYPE ROOM AIR CONDITIONER

OPERATION MANUAL

HSU-09HV03
HSU-12HV03
HSU-09LV03
HSU-12LV03
HSU-18LV03
HSU-22LV03
HSU-24LV03

Please read this operation manual before using the air conditioner

No.0010561676

Cautions

Disposal of the old air conditioner

Before disposing an old air conditioner that
goes out of use, please make sure it's inop­erative and safe. Unplug the air conditioner
in order to avoid the risk of child entrapment.

It must be noticed that air conditioner system
contains refrigerants, which require speciali­zed waste disposal. The valuable materials
contained in an air conditioner can be recycled
.Contact your local waste disposal center for
proper disposal of an old air conditioner and
contact your local authority or your dealer if
you have any question. Please ensure that
the pipework of your air conditioner does not
get damagedprior to being picked up by the
relevant waste disposal center, and contribute
to environmental awareness by insisting on an
appropriate, anti-pollution method of disposal.

Safety Instructions and Warnings

Before starting the air conditioner, read the
information given in the User's Guide caref­ully. The User's Guide contains very impor­tant observations relating to the assembly,
operation and maintenance of the air
conditioner.

The manufacturer does not accept respon­sibility for any damages that may arise due
to non-observation of the following
instruction.

Damaged air conditioners are not to be
put into operation. In case of doubt, consult
your supplier.

Use of the air conditioner is to be carried
out in strict compliance with the relative
instructions set forth in the User's Guide.

Installation shall be done by professional
people, don't install unit by yourself.

Disposal of the packaging of your
new air conditioner

All the packaging materials employed in the
package of your new air conditioner may be
disposed without any danger to the
environment.

The cardboard box may be broken or cut into
smaller pieces and given to a waste paper
disposal service. The wrapping bag made of
polyethylene and the polyethylene foam pads

contain no fluorochloric hydrocarbon.

All these valuable materials may be taken to
a waste collecting center and used again after
adequate recycling.

Consult your local authorities for the name
and address of the waste materials collecting
centers and waste paper disposal services
nearest to your house.

For the purpose of the safety,the air con­ditioner must be properly grounded in acco­rdance with specifications.

Always remember to unplug the air
conditioner before openning inlet grill. Never
unplug your air conditioner by pulling on
the power cord. Always grip plug firmly and
pull straight out from the outlet.

All electrical repairs must be carried out
by qualified electricians. Inadequate repairs
may result in a major source of danger for
the user of the air conditioner.

Do not damage any parts of the air
conditioner that carry refrigerant by piercing
or performating the air conditioner's tubes
with sharp or pointed items, crushing or
twisting any tubes, or scraping the coatings
off the surfaces. If the refrigerant spurts
out and gets into eyes, it may result in
serious eye injuries.

1

Cautions

Do not obstruct or cover the ventilation
grille of the air conditoner.Do not put fingers
or any other things into the inlet/outlet and
swing louver.

Do not allow children to play with the air
conditioner.In no case should children be
allowed to sit on the outdoor unit.

Specifications

The refrigerating circuit is leak-proof.

The machine is adaptive in following
situation

1.Applicable ambient temperature range:

32 C/23 C
18 C/14 C

43 C/26 C
18 C

27 C
15 C

24 C/18 C

-7 C/-8 C

Cooling

Heating

Indoor

Outdoor

Indoor

Outdoor

Maximum:D.B/W.B
Minimum:D.B/W.B

Maximum:D.B/W.B
Maximum:D.B

Maximum:D.B
Maximum:D.B

Maximum:D.B/W.B
Minimum:D.B/W.B

7. The appliance is not intended for use
by young children or infirm persons
without supervision.

8. Young children should be supervised
to ensure that they do not play with
the appliance.

9.Please employ the proper power plug,
which fit into the power supply cord.

10 .The power plug and connecting cable
must have acquired the local attestation.

2. If the power supply cord is damaged, it
must be replaced by the manufacturer
or its service agent or a similar qualified
person.

3. If the fuse of indoor unit on PC board is
broken,please change it with the type of
T. 3.15A/ 250V.

4. The wiring method should be in line with
the local wiring standard.

5. After installation, the power plug should
be easily reached.

6. The waste battery should be disposed
properly.

2

Cautions

Safety Instruction

Please read the following Safety Instructions carefully prior to use.

The instructions are classified into two levels, WARNING and CAUTION according to
the seriousness of possible risks and damages as follows. Compliance to the
instructions are strictly required for safety use.

Installation

WARNING

Please call Sales/Service Shop for the Installation.

Do not attempt to install the air conditioner by yourself because improper works
may cause electric shock, fire, water leakage.

lnstallation in a inadequate place may cause accidents. Do not install in the following place.

Connect the earth
cable.

earthing

Do not install in the
place where there is
any possibility of
inflammable gas
leakage around the
unit.

PROHIBITION PROHIBITION

Do not get the unit
exposed to vapor
or oil steam.

3

Check proper
installation of the
drainage securely

STRICT
ENFORCEMENT

Cautions

When abnormality such as burnt-small found,
immediately stop the operation button and
contact sales shop.

WARNING

Use an exclusive power source with a
circuit breaker

OFF

Connect power supply cord
to the outlet completely

STRICT

ENFORCEMENT

Do not use power supply cord
in a bundle.

PROHIBITION

Do not start or stop the
operation by disconnecting
the power supply cord and so on.

PROHIBITION

Do not use for the purpose of storage of
food, art work, precise equipment,
breeding, or cultivation.

STRICT

ENFORCEMENT

Use the proper voltage

STRICT

ENFORCEMENT

Take care not to damage

the power supply cord.

PROHIBITION

Do not channel the air flow directly
at people, especially at infants or
the aged.

PROHIBITION

CAUTION

Take fresh air occasionally especially
when gas appliance is running at the
same time.

Do not use power supply cord

extended or connected in halfway

PROHIBITION

Do not insert objects into the air
inlet or outlet.

PROHIBITION

Do not try to repair or reconstruct
by yourself.

Do not operate the switch with
wet hand.

PROHIBITION

Do not install the unit near a fireplace
or other heating apparatus.

PROHIBITION

Do not place animals or plants in
the direct path of the air flow

PROHIBITION

STRICT

ENFORCEMENT

Check good condition of the
installation stand

PROHIBITION

Do not place any objects on or
climb on the unit.

PROHIBITION

4

PROHIBITION

Do not pour water onto the unit
for cleaning

PROHIBITION

Do not place flower vase or water
containers on the top of the unit.

PROHIBITION

Parts and Functions

Indoor unit

Display board

Inlet

Air Purifying Filter

(inside)

Inlet grille

Vertical flap
(adjust up and down air flow.
Don't adjust it manually)

Horizontal louver

(adjust left and right air flow)

Outdoor unit

Outlet
Air filter(inside)

Anion generator

(inside)

Power plug

HSU-09LV03

HSU-12LV03

1
2

HSU-09HV03
HSU-12HV03

OUTLET CONNECTING PIPING AND ELECTRICAL WIRING

INLET DRAIN HOSE

3
4

HSU-18LV03
HSU-22LV03
HSU-24LV03

5

Parts and Functions

15

8

9
10
11
12
13

14

1

SWING FAN

2

3
4
5
6

7

30

TEMP

ON

OFF

MODE

HEALTH AIRFLOW

HEALTH

FRESH

CLOCK SET

TIMER

LIGHT LOCK

RESET CODE

SLEEP

STERILIZE

16
17

18
19

20
21

22
23
24

25

31

26

27

28

29

11. LOCK display

12. FAN SPEED display

LOW HI

MED AUTO

13. TIMER ON display

14. TEMP button
Used to select your desired temperature.

15. Operation mode display

Operation mode AUTO HEAT FANCOOL DRY

Remote controller

16. Signal sending display

17. UV light degerming function display

18. Left/right air flow display

19. TEMP display
Remote controller: to display the TEMP. setting.

20. TIMER OFF display

21. CLOCK display

22. FAN button
Used to select fan speed: LOW,MED, HI, AUTO

23. ON/OFF button
Used for unit start and stop.

24. SLEEP button

1. SWING button
Used to select up or down air sending direction.

2. HOUR button
Used to set clock and timer setting.

3. MODE button
Used to select operation mode. AUTO,
COOL,DRY, FAN,HEAT.

4. HEALTH button
Used to set healthy operation.

5. CLOCK button
Used to set correct time.

6. TIMER button
Used to select TIMER ON,
TIMER OFF, TIMER ON-OFF.

7. RESET
When the remote controller appears
abnormal, use a sharp pointed article
to press this button to reset the
remote controller normal

8. HEALTH display

9. SLEEP display

10. SWING UP/DOWN display
NOTE: (1)The following functions and related displays are not available and .

Used to select sleep mode.

25. HEALTH AIRFLOW button
Used to set the healthy airflow mode.

26. SET button
Used to confirm timer and clock settings.

27. STERILIZE button
Use to set UV light degerming function

28. LOCK
Used to lock buttons and LCD display. If
pressed, the other buttons will be disabled
and the lock condition display appears.
Press it once again, lock will be canceled
and lock condition display disappears.

29. LIGHT button
Colorful display bar of the controlling indoor
machine is on and extinguished.

30. CODE
Used to select CODE A or B with a press,A or
B will be displayed on LCD.
Please select A without special explanation.

31. FRESH button

Used to set FRESH AIR operation.

, ,

31

(2) Cooling only unit do not have functions and displays related with heating.

6

Parts and Functions

Clock Set

When unit is started for the first time and after replacing batteries in remote
controller, clock should be adjusted as follows:

1. Press CLOCK button,"AM" or "PM" flashes.

MODE

HEALTH AIRFLOW

HEALTH

FRESH

CLOCK SET

TIMER

STERILIZE

SLEEP

2. Press or to set correct time. Each press will increase or decrease 1
min. If the button is kept depressed, time will change quickly.

3. After time setting is confirmed, press SET, "AM" or "PM" stop flashing,

RESET CODE

LIGHT LOCK

while clock starts working.

Remote controller's operation

When in use, put the signal transmission head directly to the receiver hole on the indoor unit.

The distance between the signal transmission head and the receiver hole should be within 7 m
without any obstacle as well.

Don't throw or knock the remoter controller.

When electronic-started type fluorescent lamp or change-over type fluorescent lamp or wireless
telephone is installed in the room, the receiver is apt to be disturbed in receiving the signals, so the
distance to the indoor unit should be shorter.

Loading of the battery

Load the batteries as illustrated right
2 R-03 (7#) batteries

Remove the battery cover:
Slightly press" "area and push down the cover

as illustrated.

Load the battery:
Be sure that the loading is in line with the "+" / ".

request as illustrated on the bottom of the case.
Put on the cover again.

Confirmation indicator:
After pressing power ON/OFF, if no display, reload the batteries.

Note:

Full display or unclear display during operation indicates the batteries have been used up.
Please change batteries.

Used two new same-typed batteries when loading.
If the remote controller can't run normally during operation, please remove the batteries and

reload several minutes later.

Hint:

Remove the batteries in case unit won't be in usage for a long period. If there are any display after
taking-out, just need to press reset key.

7