Haier HSU-09HEA03-BP, 10518526, HSU-12HEA03-BP User Manual

SPLIT TYPE ROOM AIR CONDITIONER

OPER

ATION MANUAL

HSU-09HEA03/(BP) HSU-12HEA03/(BP)

Please read this operation manual before using the air conditioner.

0010518526

Cautions

Disposal of the old air conditioner

Before disposing an old air conditioner that goes out of use, please make sure it's inoperative and safe. Unplug the air conditioner in order to avoid the risk of child entrapment.

It must be noticed that air conditioner system contains refrigerants, which require specialized waste disposal. The valuable materials contained in an air conditioner can be recycled .Contact your local waste disposal center for proper disposal of an old air conditioner and contact your local authority or your dealer if you have any question. Please ensure that the pipework of your air conditioner does not get damagedprior to being picked up by the relevant waste disposal center, and contribute to environmental awareness by insisting on an appropriate, anti-pollution method of disposal.

Disposal of the packaging of your new air conditioner

All the packaging materials employed in the package of your new air conditioner may be disposed without any danger to the environment.

The cardboard box may be broken or cut into smaller pieces and given to a waste paper disposal service. The wrapping bag made of polyethylene and the polyethylene foam pads

contain no fluorochloric hydrocarbon.

All these valuable materials may be taken to a waste collecting center and used again after adequate recycling.

Consult your local authorities for the name and address of the waste materials collecting centers and waste paper disposal services nearest to your house.

Safety Instructions and Warnings

Before starting the air conditioner, read the information given in the User's Guide carefully. The User's Guide contains very important observations relating to the assembly, operation and maintenance of the air conditioner.

The manufacturer does not accept responsibility for any damages that may arise due to non-observation of the following instruction.

Damaged air conditioners are not to be put into operation. In case of doubt, consult your supplier.

Use of the air conditioner is to be carried out in strict compliance with the relative instructions set forth in the User's Guide.

Installation shall be done by professional people, don't install unit by yourself.

For the purpose of the safety,the air conditioner must be properly grounded in accordance with specifications.

Always remember to unplug the air conditioner before openning inlet grill. Never unplug your air conditioner by pulling on the power cord. Always grip plug firmly and pull straight out from the outlet.

All electrical repairs must be carried out by qualified electricians. Inadequate repairs may result in a major source of danger for the user of the air conditioner.

Do not damage any parts of the air conditioner that carry refrigerant by piercing or performating the air conditioner's tubes with sharp or pointed items, crushing or twisting any tubes, or scraping the coatings off the surfaces. If the refrigerant spurts out and gets into eyes, it may result in serious eye injuries.

Cautions

Do not obstruct or cover the ventilation grille of the air conditoner.Do not put fingers or any other things into the inlet/outlet and swing louver.

Do not allow children to play with the air conditioner.In no case should children be allowed to sit on the outdoor unit.

Specifications

The refrigerating circuit is leak-proof.

The machine is adaptive in following situation

1.Applicable ambient temperature range:

Cooling

Heating

Indoor

Outdoor

Indoor

Outdoor

Maximum:D.B/W.B Minimum:D.B/W.B

Maximum:D.B/W.B Minimum:D.B

Maximum:D.B Minimum:D.B

Maximum:D.B/W.B Minimum:D.B/W.B

32oC/23oC

C/14oC

C/26oC

C/18oC

C/-8oC

-7

7. The appliance is not intended for use by young children or infirm persons

without supe

rvision.

8. Young children should be supervised to ensure that th the applienc

9.Please empl which fit into the p

ey do not play with

oy the proper power plug,

ower supply cord.

10 .The power plug and connecting cable

must have acquired the local attestation.

11.In order to protect the units,please turn

off the A/C first, and at least 30 seconds later, cutting off the power.

2. If the power supply cord is damaged, it must be replaced by the manufacturer

or its service agent or a similar qualified person.

3. If the fuse of indoor unit on PC board is broken,please change it with the type of

T. 3.15A/ 250V.

4. The wiring method should be in line with the local wiring standard.

5. After installation, the power plug should be easily reached.

6. The waste battery should be disposed properly.

Parts and Functions

Indoor Unit

Display board

Inlet

Air Purifying Filter

(inside)

Inlet grille

Horizontal flap (adjust up and down air flow. Don't adjust it manually)

Outlet

Air filter(inside)

Power plug

Anion generator

(inside)

Vertical blade

(adjust left and right air flow)

Actual inlet grille may vary from the one shown in the manual according to the product purchased

Outdoor Unit

OUTLET

INLET

HSU-09HEA03/(BP) HSU-12HEA03/(BP)

CONNECTING PIPING DRAIN HOSE

AND ELECTRICAL WIRING

Parts and Functions

Remote controller

2 3 4

14 15

1. Operation mode display

Operation mode

Remote controller

Display board

2. SWING display

3. FAN SPEED display

4. HEALTH display

5. POWER/SOFT display

6. LOCK display

A U

T O

ON/OFF

MODE SET

FAN

SWING

LOCK RESET

TEMP

HEALTH

COOL DRY

ON OFF

AM PM

TIMER

CLOCK

POWER/SOFT

AUTO

HEAT

Display board

7 8

7. SIGNAL SENDING display

8. TIMER OFF display

9. TIMER ON display

10. CLOCK display

11. TEMP display

12. POWER ON/OFF

Used for unit start and stop.

13. MODE

Used to select

14. FAN

Used to select fan speed AUTO, HI, MED, LO

15. HOUR

Used to set clock and timer setting.

DRY,HEAT operation

COOL,

16. SWING

Used to set auto fan direction.

17. POWER/SOFT button

18. LOCK

Used to lock buttons and LCD

19. TEMP.

Used to select your desired temp.

20. SET

Used to confirm timer and clock settings.

21. TIMER

Used to select TIMER ON, TIMER OFF,

22. CLOCK

Used to set correct time

23. RESET

Used to reset the controller back to normal condition.

24. HEALTH

LOMED

Used to operate the healthy function

25.

Singal receiver hole

26. Ambient temp.display

When receiving the remote control signal, display the set temperature and in the rest time the room temperature is displayed and this room temperature is only for reference.

displa

Clock set

When unit is started for the first time and after replacing batteries in remote controller, clock should be adjusted as follows: Press CLOCK button, "AM" or "PM" flashes. Press or to set correct time. Each press will increase or decrease 1min. If the button is kept depressed, time will change quickly. After time setting is confirmed, press SET

, "AM "and "PM" stop flashing, while clock

NOTE: Cooling only unit do not have displays and functions related with heating

The unit do not have functions related with healthing.

Hints

After replacing with new batteries, remote controller will conduct self-check, displaying all information on LCD. Then, it will become normal.

starts working.

Operation

Remote controller's operation

When in use, put the signal transmission head directly to the receiver hole on the indoor unit.

The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well.

Don't throw the controller, prevent it from being damaged. When electronic-started type fluorescent lamp or change-over

type fluorescent lamp or wireless telephone is installed in the room, the receiver is apt to be disturbed in receivering the signals so the distance to the indoor unit should be shorter.

Loading of the battery

Load the batteries as illustrated. 2 R-03 batteries, resetting key (cylinder)

Remove the battery cover:

Slightly press " " and push down the cover.

½ ½ Á

Æ Å

, ±

· ö

Ë º º

È °

Í ¯

Æ £ º

µ Õ ¿

Load the battery:

Be sure that the loading is in line with the" + "/"-" pole request as illustrated.

Put on the cover again Confirmation indicator:

In disorderation, reload the batteries or load the new batteries after 6mins.

Note:

Use two new same-typed batteries when loading. If the remote controller can't run normally or doesn't work at all, use a sharp pointed item to press the reset key.

Hint:

Remove the batteries in case unit won't be in usage for a long period. If there are any display after taking-out just need to press reset key.

ÇëÑ¡ÓÃÍ¬Ò»Æ·ÅÆÁ½½Ú ÇëÑ¡ÓÃÍ¬Ò»Æ·ÅÆÁ½½Ú 7# µç³Ø,³¤Ê±¼ä²»ÓÃÊ±,Îª

º£¶ы¼¯НЕЗаµºº£¶ы ¿ХµчЖчУРПЮЧЬ¹«Л¾

µç³Ø,³¤Ê±¼ä²»ÓÃÊ±,Îª

³ö¡£

ФЪК¹УГЦРИзУцТм³£,Зл

½«µç³ØÈ¡³ö,6·ÖÖÓºóÔÙ

×°ÈëÐÂµç³Ø¡£

º£¶û¼¯ÍÅÇàµºº£¶û

¿ХµчЖчУРПЮЧЬ¹«Л¾

+ 12 hidden pages