HRZ-40
HRZ-40
BAR FRIDGE
Cabinet
Cool Zone
Thermostat Knob (at the rear)
Shelf
Hinge Cover
Door
Gasket
Adjustable Foot
Cool Zone Door
Door Bar
Installation InstructionsInstallation Instructions
Ventilating
To ensure adequate ventilation for your refrigerator see
recommended cabinetry dimensions below.
The refrigerator should be positioned 50mm from each wall,
and have clear space 50mm above the top of the unit.
Power Supply
To ensure that the appliance is not accidentally switched off,
connect your refrigerator to its own power point.
Do not plug in any other appliance at this power point or use
extension cords and double adaptors.
Power requirements: 220-240VAC/50Hz. It is essential that the
appliance be properly grounded (earthed).
Power Line Cord
Never unplug your refrigerator by pulling on the power
cord.
Always grip the plug firmly and pull straight out from
the outlet.
Repair or replace immediately all electric service cords
that have become frayed or otherwise damaged. Do
not use a cord that shows cracks or abrasion along its
length or at either the plug or appliance end.
Protection from Moisture
Avoid installing this refrigerator in a place where heavy
moisture is present, or where it may be directly sprayed
with water. Exposure to excessive moisture can create
an electrical hazard.
Installation InstructionsInstallation Instructions
Protection From Heat
Your refrigerator should not be located in direct sunlight or
next to any heat generating appliance such as a cooktop,
oven or dishwasher.
Positioning
Only install this refrigerator on a stable, flat floor and should
it not be laid on soft materials such as foam, plastic.
Ensure the unit is stable by adjusting the front feet.
Environment
Do not install this refrigerator near flammable, combustible
or explosive materials.
Never store volatile or flammable materials in your
refrigerator as they may explode.
Moving
When fixed or moved, the refrigerator can not be
set horizontally or inclined more than 45 or
upside-down.
Loading...