Haier HLT10 Instruction Manual

Instruction Manual

10.2” DIGITAL LCD TV

MODEL NO.: HLT10

BEFORE USING THIS PRODUCT, READ,
UNDERSTAND, AND FOLLOW THESE INSTRUCTIONS.
Save this booklet for future reference.

PLEASE

IMPORTANT INSTRUCTIONS

SAFETY INSTRUCTIONS

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK.
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
USE THE RECOMMENDED ACCESSORIES ONLY.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The graphic symbols on the back cover of the set mean the following:

The lighting flash with arrowhead symbol within an equilateral triangle is
intended to alert the user to the presence of uninsulated dangerous voltage.
Within the product's enclosure, there may be full of sufficient magnitude to
constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the
user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.

WARNING:

- TO AVOID THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS

UNIT TO RAIN OR MOISTURE. AND DO NOT PLACE CLOSELY TO FIRE, HEAT

SOURCES.

- PLACE UNIT WHERE ADEQUATE VENTILATION IS AVAILABLE.

- DISCONNECT FROM POWER SOURCE DURING LIGHTNING STORM, OUT FOR

LONG TIME OR DOING KINDS OF CONNECTIONS.

- HAVE THE PRODUCT UNPLUGGED FROM THE POWER SOURCE BEFORE

CLEANING RELOCATING OR SERVICING.

1

PRECAUTIONS

--TO PROLONG USE TIME, PLEASE MAKE SURE THE INTERVAL OF
SWITCHING ON AND OFF IS NOT LESS THAN 5 SECONDS.

--PROTECT THE POWER CORD FROM BEING WALKED ON OR PINCHED,
PARTICULARLY AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT
WHERE THEY EXIT THE PRODUCT.

USING OF POWER：

-- DO NOT CONNECT TO POWER OVER PRESCRIPTIVE VOLTAGE, USE THE
CORRECT VOLTAGE AND CURRENT MARKED ON THE PRODUCT ELECTRICAL
RATINGS LABEL. ELECTRIC POWER OVERLOAD WILL CAUSE FIRE OR ELECTRIC
SHOCK.

-- DO NOT PULL CABLES ,SHOULD HOLD PLUG WHEN USING POWER SOCKET.

-- UNPLUG AC CABLE FROM POWER SOCKET IF NOT USE THE UNIT FOR LONG
TIME.

BATTERY USAGE AND HANDING:

--KEEP BATTERY AWAY FROM CHILDREN AND PETS.

--REMOVE THE BATTERY FROM THE REMOTE CONTROL WHEN THE PRODUCT
WILL NOT BE USED FOR AN EXTENDED PERIOD.

--NEVER THROW BATTERY INTO A FIRE. DO NOT EXPOSE BATTERY TO FIRE OR
OTHER HEAT SOURCES.

FEATURES

10.2″TFT DISPLAY

Built in ATSC/NTSC Tuner.

AUTO TV SCANNING FUNCTION
MEMORY FUNCTION
SUPPORT VIDEO/AUDIO INPUT
DIGITAL BROADCASTING RECEPTION

GENERAL TROUBLESHOOTING

Check the following points before assuming malfunctions of the TV set:

Problem Reasons

No picture & sound Improper connection of AC adaptor or the battery power is low.
No picture Reception may not be adequate. Relate the unit or change the antenna

direction.

No sound Volume is too low; Mute function is switched on.

The headphone has been plugged in or the signal is too weak .
Poor reception TV antenna is not correctly adjusted or TV channel is not right.
Dark or blurred picture The bright & contrast is too low. The battery voltage is too low.
Unclear or unstable
picture

TV antenna is not properly adjusted or in too weak signal

reception area.
Picture moves up &
down,blurs or folds
over

TV antenna is not rightly adjusted.

The signal reception is too weak or caused by signal reflection

from the buildings nearby or mountains.
Interfered snow
picture

The signal is interfered by car,s engine, railway, high tension

wires, neon signs or radio frequency.
No color Color or color system is not set properly.

MAINTENANCE

• Be sure to press POWER to set the player to the standby mode and disconnect
the AC adaptor before maintaining the player.

• Wipe the player with a dry, soft cloth.

• If the surfaces are extremely dirty ,wipe clean with a cloth which has been

dipped in a weak soap-and-water solution and wrung out thoroughly, and then
wipe again with a dry cloth.

• Never use alcohol, benzine, thinner, cleaning fluid or other chemicals. And do
not use compressed air to remove dust.

23 2

Specifications

1. EARPHONE OUTPUT : ≥250mW (MAX)

2.Display device: Colour TFT LCD

3.Display Screen Size: 10.2 inches

4.Input Resistance : 75Ω

5.Power Consumption: ≤24W

6.Standby Power Consumption: ≤0.3W

7.Resolution: 800(RGB) *480

8.Dots Distance: 0.276(H) X 0.0925(V)mm

9.Visible Range: 132.48(H) X222.0(V)mm

10.Power Source: AC adaptor （normal: DC 12V

---2A)

11. Video input level: 1.0 Vp-p

12. Audio input level: 1.2V

13.Operation Temperature : -5

O

C to +45OC.

14.Measurement: 10.24 (L) X 7.48 (W) X 1.26 (D) INCH

15.Weight: Approx. 2.01 LBS (barring the weight of lithium battery)

16.Connection terminals:

1. Antenna Jack

2. Headphone Jack

3. External Power Source Input Jack

4. AV input jack

Specifications are subject to change without notice.

MULTI-LINGUAL SUBTITLES

Subtitles may be displayed in one of a multi- language depending on the software.

FULL FUNCTION REMOTE CONTROL
RECHARGEABLE BATTERY
ON SCREEN DISPLAY

ACCESSORIES

ll the pictures in the instruction manual are just for your reference, specification should refer to
actual accessories.

3 22