Haier HDW300SS, HDW300WH User Manual

Domestic Dishwasher
HDW300SS
HDW300WH

Code:0120505074

Safety Is a Good Habit to Get Into

IMPORTANT

Carefully read the instructions contained in this manual, as it pro­vides information that is essential to safe and proper installation,
use and maintenance of this appliance.

This appliance complies with following EEC directives:

- 73/23/EEC of 19/02/73(Low Voltage)and subsequent
modifications;

- 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and
subsequent modifications.

- Carefully dispose of the packing material.

- After removing the packing, check to make sure that the appli­ ance is not damaged. If in doubt, contact a qualified professional.

- The dishwasher must only be used by adults for the washing of
household dishes and cooking utensils.

- Fundamental rules to follow when using the appliance:
* Never touch the dishwasher with wet hands;
* We discourage the use of extension cords and multiple sockets;
* During installation, the power supply cord must not be exces­ sively or dangerously bent or flattened;
* If the appliance is not operating properly or, requires
maintenance, disconnect the appliance from the power supply.

- Keep detergents out of the reach of children. Also keep chil
dren away from the dishwasher when it is open to reduce the
risk of injury.

- This appliance cannot be installed outdoors or exposed to the
rain and elements. Not even if the area in which it is installed is
covered by a roof. It is very dangerous.

- Do not lean or sit on the door when it is open, as this could
overturn the dishwasher.

- If the appliance malfunctions, turn off water supply to the appli­ ance and disconnect the plug from the wall socket. Then, refer
to the "Troubleshooting". If you cannot resolve the problem,
contact an authorised service agent.

- Only specialised personnel are authorised to make repairs.

- Appliances which are being discarded must be made
inoperable by cutting the power supply cord and removing the
door lock.

- The appliance must be positioned so that the plug or isolating
switch is accessible.

- If the supply cord is damaged, it must be replaced by the manu­ facturer or an authorised service agent.

Warning:

Dishwasher Detergents can be extremely dangerous, if swallowed.
Avoid contact with skin and eyes and keep children away from the
dishwasher when the door is open.
Check that the detergent receptable is empty after completion of the
wash cycle.

Close-up View (control panel)

ON-OFF Button

A

ON-OFF Light

B

"HALF LOAD" Button

C

Low rinse aid indicator light

D

D

HG

F
G
H
I

I

Cycle indicator light

Cycle select button
"HALF LOAD" indicator light
Delay indicator light

BCEF

A

J

GB

Water heating indicator light

E

.1.

Delay select button

J

Close-up View (Interior)

K
J

I

H

A Cup Rack
B Upper Rack

A

B

V

C
D

E

F

J

G

L

G Washing Filter

H Detergent and Rinse Aid Dispenser
C Rack Height Adjustor
D Top Spray Arm
E Lower Rack
F Bottom Spray Arm

Technical characteristics

Width
Depth
Height
Capacity
Mains water pressure
Power voltage
Total absorber power

I Silverware basket

J Knife rack

K Third Sprayer

60 cm

60 cm
85 cm

12 standard place settings

0.03-0.6MPa

220-240V~ 50Hz

2150W

.2.

GB

Detergent and Rinse Aid







Detergent

Detergent specifically intended for use with dishwashers must
be used. The dispenser must be refilled before the start of each
wash cycle following the instructions provided in the "Wash Cycle
Table". The detergent dispenser is located on the inside panel of
the door.

Loading the detergent

To open the "A" cover on the dispenser, press the "B" button.
The detergent for the wash cycle should be poured into the "C"
compartment.
After the detergent has been placed in the dispenser, close the
cover and press down until it clicks into place.

C

A

B

Rinse Aid

This product makes dishes sparkle and helps them to dry with­out spotting. The dispenser is located on the inside panel of the
door and should be filled after approx every 80 wash cycles (or
when the "low rinse aid" indicator light comes on for those mod­els with this feature).

Loading the Rinse Aid

Regardless of the type of detergent dispenser installed on your
appliance, you must proceed as indicated below when loading
the rinse aid.
To open the dispenser, turn the "C" cap in an anti-clockwise
direction and then pour in the rinse aid, making sure not to overfill.
The amount of rinse aid used for each cycle can be regulated by
turning the "F" dose adjustor, located beneath the "C" cap, with
a screwdriver. There are 6 different settings; the normal dosage
setting is 1.

Important

Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs,
the dosage adjustor should be turned to a higher setting.
If the dishes have white streaks, turn the dosage adjustor
to a lower setting.

Notice: To enable the cover to close, remove any ex­cess detergent from the edges of the dispenser.

GB

C

F

C

.3.