HDW201SS
Domestic Dishwasher
HDW201WH
HDW201SS
User Manual
Code:0120502719
Safety
Carefully read the instructions contained in this manual, they provide
important information which is essential to safe and proper
installation, use and maintenance of this appliance.
This appliance complies with the following directives:
-73/23/EEC of 19/02/73 (Low Voltage) and subsequent
modifications;
- 89/336/EEC of 03/05/89 (Electromagnetic
Compatibility) and subsequent modifications.
-
Carefully remove and dispose of the packing material.
- Check to make sure that the appliance is not damaged. If in doubt,
contact the retailer it was purchased from.
- This dishwasher is designed for washing household dishes and
cooking utensils.
- Do not install this appliance outdoors exposed to the rain and
elements even if a roof covers the area.
- Do not lean or sit on the door when it is open as it may overturn
the dishwasher.
- If the appliance malfunctions turn off water supply to the
appliance, disconnect the plug from the wall socket and refer to
the section entitled, "Troubleshooting." If you cannot solve the
problem, contact an authorised service centre.
- Only selected service centres are authorised to make repairs.
- Appliances that are being discarded should be made inoperable by
cutting the power cord and removing the door lock.
- If the power cord is damaged, it must only be replaced by an original
assembly available from the manufacturer or its service agent.
- This appliance is intended for built-in and must be installed ac
cording to the installation instructions.
- The plug must be accessible after installation.
- Do not use extension cords and multiple sockets.
- During installation, the power supply cord must not be bent or
flattened excessively.
- If the appliance is not operating properly, disconnect the appliance
from the power supply.
Warning: Dishwasher d etergents can be extremely dangerous if
swal lowed. Avoid c ontact with skin and eyes and keep children
away from the dis hw ashe r w hen the door is open. Check tha t t he
detergent receptacle is empty after completion of the wash cycle.
To maintain the EFFICIENCY and SAFETY of this appliance: -
- Only call a Haier authorised service centre.
- Always use original Spare Parts.
Control Panel
A ON-OFF Button
B ON-OFF Light
C 1/2 Load Button
D 1/2 Load Indicator Light
E Delay Select Button
F Delay Time Indicator
G Cycle Select Buttons
H Cycle Indicator Lights
I Start / Pause Button
J Low rinse Aid Indicator
K Water heating Indicator
L Door Handle
.1.
Interior View
A
Upper Rack
B Rack Height Adjustor
C Top Spray Arm
D Lower Rack
Washing Filter
F
G Turbo Dry-fan
H Detergent and Rinse Aid Dispenser
I Third Sprayer
E Bottom Spray Arm
Technical Information
Width 60cm
Depth 60cm
Height
Capacity
Mains Water Pressure 0.03 – 0.6 MPa
Power Voltage
Total Power 2200 W
85cm
12 standard place settings
220-240V~
.2.
Detergent and Rinse Aid
Detergent
Only detergents specifically intended for use with dishwashers must
be used. The dispenser must be filled before the start of each wash
cycle following the instructions provided in the "Wash Cycle Table."
The detergent dispenser is located on the inside panel of the door.
Loading the Detergent
Open the cover "A" on the dispenser, press the button "B". Then
pour the detergent for the wash cycle into the compartment "C".
After the detergent has been loaded, close the cover and press it
down until it clicks into place.
C
Rinse Aid
This product makes dishes sparkle and helps them to dry without
spotting. The dispenser is located on the inside panel of the door
and should be filled after approximately 80 wash cycles (or when
the rinse aid indicator light comes on for those models with this
feature).
Loading the Rinse Aid
Open the dispenser by turning the cap "C" in an anti-clockwise
direction and pour in the rinse aid. ( Do not overfill ). To regulate the
amount of rinse aid dispensed during each cycle, turn the dose
adjuster "F", located beneath the cap, with a screwdriver. There are
6 different settings; the normal dosage setting is 3.
Important
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs, the
dosage adjustor should be turned to a higher setting. If the dishes
have white streaks, turn the dosage adjustor to a lower setting.
B
Note : Remove excess detergent from the edges of the
dispenser before closing the lid
.3.
Loading...