Haier FCD-JTHMG60- E, FCD-JTHMG100- E, FCD-JTHMG50- E, FCD-JTHMG80- E User Manual

Silver Sea-ox

Haier Household Electric Water Heater

User's Manual

Qingdao Economic and TechnologicalDevelopment District

Group

Haier Water Heater Co., Ltd.

Add:Haier Garden, Qianwangang Road, Economic

Development Zone, Qingdao, P. R. China

Rev. 01 Specific Number:0040501638

Please read this manual before usage Retain it for future regerence

Pre-safe Expert

Mark of

Haier Safe Water Heaters

This mark is the designation for Pre-Safe Expert of

Haier Water Heater Company, which indicates use of the company's patented technology inside the product. It ensures you a safe bath while monitoring whether your house ground wire is live or not all the time. If this mark is lighted on, it indicates your house ground wire has come live (poor grounding and live). In this case, please immediately stop use and unplug from the power supply, and remember not to touch any electric appliance shell in your house. At the same time, immediately contact after-sales service and your property management company for professional repair until the mark goes off. Pre-Safe Expert will become the electric safeguard for your family.

Cleaning and Maintenance

Statement:

Note:

External Cleaning: Disconnect power supply before cleaning. Gently wipe with wet cloth dipped with a little of mild detergent. Do not use gasoline or other solvents. Finally dry with dry cloth. Keep water heater dry. Do not use cleansers containing grinding agent (e.g. toothpaste), acids, chemical solvents (e.g. alcohol) or polishers to clean. Internal Cleaning: To ensure high working efficiency, heating elements and tank liner of water heater shall be cleaned once in three years. Take care not to damage protection layer on heating elements and tank liner inner surface. According to different local water qualities and use habits, magnesium anode rod shall be periodically replaced. If maintenance is needed, please contact local service station.

Tank Liner Cleaning: Do pull out power plug before cleaning. To clean, close water inlet valve, open outlet valve, take down drain plug and empty the tank. Then open water inlet valve to flush for several minutes until clean water flows out. Fit the drain plug back.

This water heater shall only be repaired and maintained by qualified servicemen. Improper maintenance may cause severe injury or damage.

Before opening or repairing water heater, please do pull out the power plug. Before asking for service, please refer to troubleshooting section to resolve easy problems.

Contents

Before USage

Special reminding

Features Views and parts

Safety precautions

Setting environment

Parameters Dimensions

2-3

4 5

5 6

Installation

Attentions in Installation

Installation

Operation

Correct Disposal of this product: This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.

See to the physical product for the appearance,color or pattern.

Control panel illustration

Remote controller panel illustration

Operation instructions

Operation diagram

Attentions in operation

Use of remote controller

Electric Circuit Diagram

FAQ

Cleaning and maintenance

FAQ

Packing list

8-12

FAQ

Problems

No outlet water

Outlet water is cold

Outlet water flow and temperature is not steady

Unable to start machine

Error display of E1

Error display of E2

Error display of E3

Possible Causes to be Confirmed

If water supply is stopped or water pressure is too low

If use point is blocked or if hot water valve is open

If water temperature is properly adjusted

If thermostat is out of control

Heating time is too short

If city water pressure is steady

If components are damaged

Circuit fault

If tank is full of water or if components are damaged

If sensor is damaged

Corrective Measures

Check

Check and clean

Re-adjust

Contact service station

Continue heating

Check

Contact service station

Fill water full or contact service station

Contact service station

Packing List

Name

Quantity

Water Heater (set)

Safety Valve (pcs)

Expansion bolt (pcs)

Expansion hook (pcs)

User manual (copy)

Battery (pcs)

Remote controller (pcs)

Drain hose (ply)

Use of Remote Controller

button: Power on / off the machine. In off status, clock time is displayed and can be

1. adjusted by pressing Set button, and or button.

Mode button: With machined powered on, you can lightly press Mode button to shift between Real-time Heat / Warm, Medium Warm, Night Power, Time 1,Time 2,Time 1+Time 2 and Intelligent operation modes. In Medium Warm mode, default highest temperature is 40 and can't be adjusted. In Time 1 and Time 2 modes, default heating power is 2150W and can't be adjusted.

Ppwer button: With machine powered on, press this button to shift heating power level between 850 W, 1300 W and 2150 W.

or button: Same as Adjust button on control panel. If not in clock or delay time

adjusting status, you can use or button to increase or decrease temperature setting value between 35 - 75 with an increment 1 . If in clock or delay time adjusting status, these buttons can be used to increase or decrease time. Set button: Press it to set clock time, and press or button to adjust the value. Press

Confirm button after adjusting. In Real-time Heat / Warm mode, press Set button to adjust clock hour and minute together with Confirm button. In Time 1 mode, press Set button to set Time 1 hour and minute. In Time 2 mode, press Set button to set Time 2 hour and minute. In Time 1 + Time 2 mode, press Set button to set Time 1 hour and minute, and Time 2 hour and minute. In addition, in Medium Warm mode and Intelligent mode, Set button is inactive.

Notes:

1. Remote controller buttons (except Set button) are used in the same way as buttons with same name on control panel. After adjustment is made with Set button, press Confirm button to confirm.

2. Remote controller has a memory function. Upon re-starting after powering off, original settings keep unchanged.

3. As an optimum, remote controller shall be used in short distance pointing to the machine vertically. Water immersion shall be avoided. If battery is used up, to prevent battery liquid pollution, please open battery cover in indicated direction, remove used batteries and replace with new batteries installed as original. To avoid explosion, used batteries shall not be kept in hot places or put in fire, but shall be treated in accordance with related local regulations.

Electric Circuit Diagram

L: Brown wire N: Blue wire MT: High temperature limiter EH: Heating element RT: Sensor E:Yellow/green wire

Leakage Coil

Relay

HEATING

SET

KEEPING

ACTUAL

Before Usage

Dear users, Thanks for choosing Haier water heater product.

Haier

products have good quality and excellent performance. To facilitate you to use the product, please read the manual and operate accordingly. Please retain it for future reference. The international star service of Haier Group will always accompany you. No matter what kind of problems you meet in usage, please contact with the local after -sales service agent. We are at your service all the time. Thanks again for choosing Product.

Haier

The water heater you purchased may not full comply with the manual due to the improvement of product. We apologize for the inconvenience occurred therefrom.

Special Reminding

To ensure proper and safe use of the water heater, we hereby sincerely declare that users shall contact our designated professional service providers for installation and service. For inappropriate installation, Haier would not undertake any liability.

Do disconnect the power supply before any maintenance and repair on the water heater. Unprofessional persons shall not adjust or repair the water heater. Make sure the machine is full of water before powering it on, otherwise heating element may be damaged. Do ensure power socket complies with local standard and is reliably grounded. Ungrounded use is forbidden. This electric water heater is provided with a safety valve, which shall not be randomly relocated or blocked. Hot water above 50 may burn your skin. Do mix hot water and cold water before showering or washing. At an ambient temperature below 0 , possible ice formation within pipes may break the pipes and cause the machine inoperable. Protection shall be made by emptying water in the tank. In case the water heater will not be used for more than 1 month, please empty the water and unplug the power plug. If the electric water heater is heavily wetted by water, it should be checked by our authorized technicians before next use. Hot water inside the water heater is not drinkable. Due to long time use, sediments will form inside the tank, and water quality may also deteriorate due to pipe aging. After washing rice and vegetables with water from the tank, please flush again with clean water. Please do not place flammable matters like gasoline nearby the water heater, otherwise accidents like fire may occur.

Features

1. High Technology:

Full PC controlled. Display indicates the actual water temperature, temperature setting, clock and working state. Upon faults, power supply is automatically cut off and the display indicates fault code. The intelligent heating feature reflects a more humanized design.

+ 5 hidden pages