Habey FW-1034 User Manual

www.habeyusa.com www.habeyusa.com

FW-1034

Quick Setup Guide

Packing List

Description QTY

FW-1034 1

Power Cable 1

Power Connector 1

Driver Disk 1

Rack Mount Ears 2

Case Stands 4

Rack Mount Screws 4

Drive Mounting Screws 4

Safety Warning:
The use and installation of this system should only be performed by
professionals. Improper installation of any electronic device or electrical
component can result in serious injury or death. Please make sure that all
safety precautions are taken into account.

21015 Commerce Pointe Drive, Walnut, CA 91789

www.habeyusa.com www.habeyusa.com

Install Guide

Step 1 - Inspect Contents

Unpack all package contents and inspect
each component. Make sure all included parts
and accessories are present.

Step 2 - Remove Top Cover

Using a phillips head screw driver, remove the
four screws on the sides of the enclosure and
two screws on the rear side of cover.

Step 3 - Mounting a 3.5” Drive

Remove the two drive trays from the
enclosure by removing the screws at the base
of the bracket.

Mount the completed bracket to the enclosure.

Step 4 - Install Memory

Plug the memoria dimm into the slot.

Step 5 - Mounting

Mount the ears to the front side of the
enclosure by securing the ears to the side of
the enclosure with the included screws.

Mount the 3.5” drive between the two drive
trays. Connect the HDD cable to the 3.5” hard
drive.

Step 6 - Hardware Installation Complete

Your system is now ready. Connect the power cable to a power source and
press the power button on the front of the system.