Habey BIS-6761 User Manual

www.habeyusa.com www.habeyusa.com

BIS-6761

Quick Setup Guide

Packing List

Description QTY

BIS-6761 1

Power Cable 1

Power Adaptor 1

HDD Mount Screws 4

Safety Warning:
The use and installation of this system should only be performed by
professionals. Improper installation of any electronic device or electrical
component can result in serious injury or death. Please make sure that all
safety precautions are taken into account.

21015 Commerce Pointe Drive, Walnut, CA 91789

www.habeyusa.com www.habeyusa.com

Install Guide

Step 1 - Inspect Contents

Step 2 - Remove Top Cover

Step 3 - Install RAM

Unpack all package contents and inspect
each component. Make sure all included
parts and accessories are present.

Using a phillips head screw driver, remove
the four screws on the sides of the enclosure.

Align notch in memory circuit with
corresponding guide on the memory slot.
Insert the memory circut at a 45° angle and

press the circuit at and secure it to the

memory slot with an audible click on each
side of the memory slot.

In order to connect the 2.5” HDD to the HDD
port correctly in the next step, make sure the
HDD head is on the opposite side of the top
mounting screw hole.

Mount the HDD on the tray with the four
screws in the small plastic package.

Make sure the HDD port in the right position,
and then connect the 2.5” HDD head to the
HDD port.

Finally, tighten the three screws on the
bottom cover.

Step 4 - Install 2.5” HDD

Using a phillips head screw driver, remove
the three screws on the bottom cover.

Step 5 - Hardware Installation Complete

Your system is now ready. Connect the power cable to a power source and
press the power button on the front of the system.