Guardian AC5000 User Manual

FLT5250PT Filter-C-Pet True HEPA GENUINE Pet Pure™ Replacement Filter

AIR CLEANING LAYERS

AC5000 SERIES

OPERATING INSTRUCTIONS

BEFORE OPERATING THE AIR PURIFIER:

1. Carefully remove your air purifier from box and bag.

2. Select a firm, level and flat location for the air purifier.

* For proper air flow, locate the unit at least 1 foot from any wall
or furniture. * Make sure none of the grills are blocked.

3. Plug the power cord into a 120V AC outlet.

IMPORTANT: When moving the air purifier, always lift unit by the carrying handle
located on back.

OPERATING THE AIR PURIFIER:

1. Turn the air purifier ON by rotating POWER KNOB clockwise.

2. Upon turning the air purifier ON, the power indicator will be lit (green)

and the unit wil be in LOW mode ( ).

3. Rotate the POWER KNOB clockwise to set the air purifier to MEDIUM (

) or High mode ( ).

4. To activate the UV-C Bulb, press the UV button. Press the button again

to turn OFF the UV-C Bulb.

5. To turn the unit OFF, rotate the POWER KNOB counter-clockwise to OFF

mode (•).

INSTALLING & REMOVING COMBINATION
FILTER

CHANGE FILTER INDICATOR

The green power light on the air cleaner will turn red and flash continuously

indicating that it is time to replace the filter. Replace the filter according to the
directions then press the UV control button and hold for 5 seconds to restart the
system. The light will turn back to green. Depending on usage, filter will last
approximately 6 months.

2. Press the Lock & Release on the filter for correct Button and remove
the installation direction.

Rear Cover from the unit.

5. Reattach the Rear Cover of the unit and securely latch into place.

6. Push and hold UV Control Button for 5 seconds to reset Filter Change Indicator.

CLEANING & MAINTAINING

THE COMBINATION FILTER

The air purifier should be cleaned at least once every month and the outer Pre-

/Charcoal Filter attached to the Filter should be cleaned every month. More
frequent cleaning may be required depending on environmental conditions.

PRE-/CHARCOAL FILTER

Clean with the brush attachment of your vacuum cleaner. This will remove lint and

dirt.