GSI PNEG-462 User Manual

Air Diffuser Instructions

AutoFlow Top Dry

42" Fan

PNEG-462

10-12-94

1. Mark and drill one 3/8” hole in the center of long side of each diffuser hanger. Mark and
drill two 3/8” holes in the short side of each hanger.

2. Bolt the long side of the hangers to the endmost slots of the top plate (TD-100665) as
shown below.

3. Hold the top plate up under the bottom flange of the “C” channel in front of the fan
opening. Mark and drill four 3/8” holes into bottom flange using diffuser hangers as a
guide. Using 5/16” x 3/8” bolts and nuts bolt the top plate to the “C” channel.

Top Plate

TD-100665

Self-drilling Screws

S-7229

Air Diffuser Hangers (2)

TD-100750

Self-drilling Screws

S-7229

4. Attach front plate to the top plate with four 1/4” x 1” self-drilling screws.

5. Bolt the side brackets in the front plate slot with the angles outward. Field drill two holes
(on inside corrugation hills) through the sidewall and install 5/16” x 3/4” bin bolts and
nuts.

6. Position the side plates on each side with the angle outward and fasten in place using six
1/4” x 1” self-drilling screws.

NOTE: The corner bolt will need to be removed and reinstalled through the side plate,
side bracket and front plate.

Self-drilling Screws

S-7229

Left Side Plate

TD-100664

Right Side Plate

TD-100663

Front Plate

TD-100655

Side Bracket

TD-100656

Self-drilling Screws

S-7229

Grain Systems Inc., • 1004 E. Illinios St. • Assumption, Il 62510 • [phone]Grain Systems Inc., • 1004 E. Illinios St. • Assumption, Il 62510 • [phone]

Grain Systems Inc., • 1004 E. Illinios St. • Assumption, Il 62510 • [phone]

Grain Systems Inc., • 1004 E. Illinios St. • Assumption, Il 62510 • [phone]Grain Systems Inc., • 1004 E. Illinios St. • Assumption, Il 62510 • [phone]

11/1/9411/1/94

11/1/94

11/1/9411/1/94