GSI PNEG-1850 User Manual

Page 1
1004 East Illinois Street • Assumption, IL 62510 • 1-217-226-4421
PNEG-1850
Drill three (3) 7/16" holes in sidewall to mount Stir-Ator standoff bracket (CRP-7135). Do not place bracket on stiffeners and space brackets to avoid roof beam stiffener bracket.
Mount Stir-Ator standoff bracket for HSR (CRP-7135) to the sidewall using 3/8" x 1" bin bolt (S-455) and 3/8" flange nut (S-9373). Center of the top hole of the bracket should be 10" below the horizontal seam.
Instructions
High Snow Load Roof with
Stir-Ator Instructions
Date: 11-14-11 PNEG-1850
Printed in the U.S.A. Copyright © 2011 by GSI Group www.gsiag.com
Figure 1
Version: 1.0
Page 1 of 3 CN-206048
Page 2
High Snow Load Roof with Stir-Ator Instructions
10"
Space brackets (CRP-7135) so that they do not interfere with the roof support brackets.
Figure 2
Page 2 of 3 PNEG-1850
Page 3
High Snow Load Roof with Stir-Ator Instructions
Attach rice-track bracket (DMC20051) to Stir-Ator standoff bracket (CRP-7135) using two (2) 5/16" x 3/4" bolts (S-275) and two (2) 5/16" flange nuts (S-3611).
Mount the Stir-Ator standoff bracket to the rice-track bracket using only the outside two (2) holes. No drilling required for this attachment. Do not use inside set of holes.
Figure 3
NOTE: For High Snow Roof instructions, please refer to PNEG-1801 (30'-48' diameter) or
PNEG-1844 (60' diameter).
NOTE: For Design III Stir-Ator instructions, please refer to PNEG-1156, PNEG-1158 and PNEG-1174.
PNEG-1850 Page 3 of 3
Loading...