GSI PNEG-1794 User Manual

Instructions

PNEG-1794

1004 East Illinois Street • Assumption, IL 62510 • 1-217-226-4421

1. Be sure and use caulking that is provided on all seams and corners throughout the assembly.

2. Bottom panel flanges should always be on the “outside” of the transition assembly. Refer to bottom
panel flange detail in Figure 1 for proper flange direction and assembly of individual flange type.
Bolt bottom panel to all entrance collar braces and side entrance collar pieces. Be sure and use
5/16" x 3/4" bolts and nuts.

3. Install and bolt top entrance collar to entrance collar braces and side pieces. Bolt transition sides to
bottom panel. After sides are complete, bolt top panel into position. Be sure and use 5/16" x 3/4" bolts
and nuts on all pieces.

4. Field cut hole in bin sidewall 68-1/4" x 11-3/4" to allow transition to fit properly.

5. Install entrance collar mounting brackets to transition on inside of bin. Be sure and use 5/16" x 3/4"
bolts and nuts.

6. Using 5/16" x 1-1/4" bolts and nuts, install entrance collar mounting brackets to bin sidewall. Installer
must seal between bin sidewall and entrance collar mounting brackets. No sealer is provided.

7. After putting transition on bin, locate sizing angle to curvature of bin, screw to top entrance collar and
to bin sidewall. Use #10 x 1" screws.

Installation of TR-8006

Date: 01-28-11

Printed in the U.S.A.
Copyright © 2011 by GSI Group
www.gsiag.com

Figure 1 Bottom Panel Flange Detail

PNEG-1794

Page 1 of 2

Installation of TR-8006

TR-8006 Parts List

Ref # Part # Description Qty

1 TR-8001 Transition Bottom Panel 1

2 TR-6196 Side Entrance Collar 2

3 TR-8002 Transition Left Side Panel 1

4 TR-6192 Top Entrance Collar 1

5 TR-8000 Transition Top Panel 1

6 TR-6312 Entrance Collar Brace 4

7 TR-8003 Transition Right Side Panel 1

8 TR-6476 Entrance Collar Mounting Bracket 2

9 TR-6194 Sizing Angle 1

N/S S-275 Bolt, HH Bin 5/16"-18 x 3/4" YDP Grade 5 130

N/S S-277 Bolt, HH Bin 5/16"-18 x 1-1/4" YDP Grade 5 10

N/S S-396 Hex Nut 5/16"-18 YDP Grade 2 140

N/S S-7621 Screw, SDS #10-16 x 1" HWH ZN Grade 2 36

N/S S-4458 Sealant, Caulking 1/8" 3

Page 2 of 2 PNEG-1794