GSI PNEG-1786 User Manual

Instructions

PNEG-1786

Shinko Controller

1004 East Illinois Street • Assumption, IL 62510 • 1-217-226-4421

Setup (056-1954-9)

Introduction

Depending on the input settings, the Shinko Controller (056-1954-9) can be set up for three (3) possible
configurations. Refer to charts on Page 2 for the input settings to designate the controller.

Instructions

Figure 1

Programming Sub Setting Mode

1. Power-up the unit.

2. Press UP ARROW and simultaneously press the MODE KEY (Basic Setting Mode).

3. Use arrow keys to change the setting values.

4. Set setting values for the controller type according the programming table.

5. Press MODE KEY to enter setting and step to the next function.

6. Repeat Step 3 through Step 5 until all modes “PROP BAND” through “PROP CYCLE” are
properly set.

Programming Auxiliary Function Mode 2

7. Simultaneously press DOWN ARROW and the MODE KEY for approximately 3 second or until
“Loct” is displayed (Auxiliary Setting Mode).

8. Repeat Step 3 through Step 5 until all modes “VALUE LOC” through “OUTPUT HYST” are set.
NOTE: Basic setting modes cannot be changed when the value lock is set as 1, 2 or 3.

9. Change lock value to “LOCK 2” when finished programming.

Date: 12-28-10 PNEG-1786

Printed in the U.S.A.
Copyright © 2010 by GSI Group
www.gsiag.com

Page 1 of 2

Shinko Controller Setup (056-1954-9)

Programming Auxiliary Function Mode 1

10. Press DOWN ARROW and simultaneously press the MODE KEY for approximately 3 second or
until is displayed (Auxiliary Setting Mode).

11. Repeat Step 3 through Step 5 on Page 1 until all modes “VALUE LOCK” through “OUTPUT HYST”
are set. NOTE: Basic setting modes cannot be changed when the value lock is set as 1, 2 or 3.

12. Finally, write part number and description on unit.

Settings Chart

Terminal Chart

Old Terminal New Terminal

Power

Alarm

Output

RTD

Sensor

Page 2 of 2 PNEG-1786

10 1

5 2

83

94

6 6

7 7

18

29

310